- Auto trans problem . Sluggish
- DSSR - anyone use one?
- "bitch clip" replacement?
- New clutch and other stuff...
- Radiator Water leaking from Auto Tranmission
- whiney, jake-braking ti
- 97ti Transmission swap check list.
- So what do you think?
- what shifter linkage/carrier to use for m52/zf trans
- M20 gearbox on M52?
- Flywheel Bolts Broke and Fell Out !
- Single Mass Flywheel Clutch
- 1996 BMW 318ti Tranny Issue
- What kind of oil i can put in my M42 gearbox manual?
- Is this a worn clutch or a bad clutch/slave cylinder?
- HELP!!! Tranny problem
- Researching auto to 5 speed swap and need help
- Automatic is shifting only at higher RPMs
- just got a 318ti and problem........help please
- Auto Tranny not selecting
- Possible to swap shift knobs?
- single or dual mass flywheel
- zf tranny to m44
- 95 third gear issue
- z3 shifter swap
- Clutch/Flywheel Replacement...Gear box too?
- automatic, hold that gear
- Drive shaft question.
- Z3 3.0 shifter
- Another 6speed trans model option...
- Please Help Error code 1750
- 310R Input&Output Shaft Seals
- Short Shift option for Swap guys
- shift boot plastic ring
- Changed my shifter bushings!
- Feeler: Weighted Selector Rod
- drive shaft thump in low gears
- Help.... I'm stuck in first gear
- 328 auto transmission swap que.?
- Bleeding clutch goofiness...
- 3rd gear popping out (manual 5 speed)
- Where can I find U-Joints?
- It's Back!
- 1995 318TI Auto Transmission Issues
- No Clutch Pressure
- What's wrong with my transmission?????
- 318ti with M52 2.8 engine swap
- Parts needed for auto to manual?
- ZF vs Getrag gear ratio question
- What oil to use for manual gboxes ?
- Clutch Replacement Questions
- G250 from a Z3
- 6 speed swap
- Car jolts when I put in in reverse, drive, or park
- 91 525i shifter assembly onto a getrag250 tranny...is it possible
- Clutch release fork not lining up with hole for slave cylinder
- Flywheel alignment on clutch job?
- Question on 6 speed getrag
- Propshaft (front driveshaft) length?
- 1999 318ti Transmission Issue?