View Full Version : 318 ti sport compact clock/temp gauge
hi
i was wondering if anyone had upgraded there compacts interior clock to the one with the external temperature sensor fitted?.the standard clock has 4 wires going to the back the one with the temp on has 12.any help would be appreciated.
clex2
03-26-2005, 07:48 PM
I've done it. There is a OBC retrofit kit (wiring only). The wiring is somewhat involved, but not impossible. You'll need a new OBC to replace the clock. It give you outside temp, MPG, and ave MPH. You will need a new turn signal stalk to control it. If you get the OBC and stalk from a wrecker and the wiring from a discount dealer, it not too expensive. Maybe $100-150 tops. Is it worth it. Depends. For me, I just had to do it, just for the fun of it.
cheers for reply.i have the obc and external temp sensor.i will get the stalk next.if you could help me with the wireing i would be very gratefull.
do you know were i can get the retrofit wiring kit from?
clex2
03-26-2005, 11:12 PM
The wiring is a kit. Part number 61-12-9-405-244 is $41.46 from Nick Alexander BMW in Los Angeles with BMW CCA discount. BTW, this place has some of the best prices for BMW parts. Something on the order of cost + 20%, plus 10% CCA discount. Can't beat that.
bmrti
05-18-2005, 08:47 PM
Can the wiring be easily removed from the car pulling the OBC and signal stalk from or is it just better to get the wiring kit?
clex2
05-18-2005, 09:08 PM
It would be easier to get the kit. BTW, no more discouts at Alexander BMW.....booooooo.
bmrti
05-18-2005, 11:15 PM
Can this wire kit be purchased right from the dealer? I asume that is a BMW part #? Where should the other end of the wiring attach? Does it go right from the OBC to the signal stock?
Funny I just bought the signal stock and OBC thinking that was all I needed for the upgrade then notice the connector difference on the OBC. Glad I found this thread.
I also bought the alarm/remote lock module. I'm about to install it too.
Fred
95 ti Sport
bmrti
05-19-2005, 01:22 AM
Do either of you remember how long the wires are coming off the signal stock? Mine were cyt. I asume there should be a connector on the other end? Would I be able to use the wires coming off my existing signal stock or would there be less wires on it?
Many thanks
Fred
vBulletin® v3.8.8, Copyright ©2000-2024, vBulletin Solutions, Inc.