PDA

View Full Version : he's here!

Clemente
09-09-2005, 07:16 AM
Just got my motor/tranny/ecu, and driveshaft! Now where the hell do i find the engine code on this thing? here's some pics! This diff is from a 98 m3. will it bolt up to an m-roadster rear?
Clemente
09-09-2005, 07:17 AM
did'nt mean diff I meant driveshaft!
Dredder
09-10-2005, 11:23 AM
Good luck on your project.. Keep us updated on your progress....
myblueTI
09-10-2005, 04:45 PM
Lucky!
Clemente
09-11-2005, 03:15 AM
My M-Roadster rear should be coming in soon! I am starting to fabricate the turbo setup, just waiting on my turbonetics manifold. Can't wait! Do you guys think I should go with the UUC m3 flywheel or the e34 M5 flywheel? (also UUC)
Dredder
09-11-2005, 05:43 AM
Are you planning to do a DIY turbo or turbo kit? M5/uuc flywheel should be sufficient for your application. Might as well use uuc stage 3 clutch if your planning to run over 400rwhp.



My M-Roadster rear should be coming in soon! I am starting to fabricate the turbo setup, just waiting on my turbonetics manifold. Can't wait! Do you guys think I should go with the UUC m3 flywheel or the e34 M5 flywheel? (also UUC)
Clemente
09-12-2005, 12:24 AM
It will be a DIY Turbo. I was thinking M5 as well. You don't think the stage 3 is too much?