I have a complete OEM kit that I have mostly installed. There are three harnesses, and a sh!t load of wires. Most of the install is straight forward, but I still can't figure out where three of the wires go. If you have no experience, and are trying to do an OEM retrofit, better take it to an expert.

F the foglamps

just get some ZKWs. then misalign them for **** and giggles.

and when some one gets PO'd. Hit 'em with the Hi beam.

teaches them every time not to mess with German Tech.

Install help
 

ok i just got the fog lights for my Ti the problem is that i cant seem to find a way to connect the brown and grey write. The diagram in the instructions is for an M3 model so its hard for me 2 wire it up any help?:biggrin: Thanks

Brown is usually a ground wire. Where is the grey one coming from?

Fog lite problem still!
 

Well i managed to connect the brown and grey wire into the car where the headlight switch is at. But as soon as i did the green fog light switch turned on. But it turns off whenever i turn on the headlights.:eek: I checked the instructions and did exactly as it said. The instructions are at the bottom 4 you guys 2 check it out. See if u know what the problem is cuz i sure dont. :confused:

more
 

ey i talked to my brother and he said it could be that the fogs are not getting enough ground which is causing it to light up this way. Is this true?

I seem to have two relays laying around as part of the fog light retrofit kit. Can anyone confirm the part # of the fog light relay? One of the relays is silver metal, the other is black plastic.

i set mine up completely different than the instructions.....but my light i my switch also burnt out cause it was always on

Finished
 

Well i finally found out what i did wrong. But it was also confusing because the wiring kit had the brown wire as positive and the grey wire as negative. But at least im done check it out. Wat u guys think?:biggrin:

http://i210.photobucket.com/albums/b...ano411/fog.jpg

looks goood