From a stop, 1st gear 'pops' - Advice? OK so as the title states, I'm having a problem with my transmission/clutch. 1998 318ti (10/97 prod date) 160K Symptoms are: From a dead stop, when I put the car in 1st, it will pop back out about 50% of the time. No other problems with any other gears, not even Reverse. I've just gotten done replacing ALL shift bushings and seals in the Pelican Parts shifter bushing rebuild kit. I've also, in the last 2K miles, drained and filled the gearbox and differential with the appropriate Royal Purple fluid. Synchromax in the gearbox and MaxGear in the differential. I've also replaced the transmission mounts about 2K miles ago. After ordering the Shift Bushing Super Kit which replaces the following: Shift coupler with internal bushingI still have the 1st gear pop. The shifts in all other gears as SO crisp and it really feels like a new tranny but 1st gear is obviously still acting up. After reading a few service bulletins it seems there are resolutions that cite when you have this problem with 1st & 2nd gear due to the guide sleeve, it calls for a tranny rebuild or replacement. I've also seen another service bulletin that quotes BMW as saying that problems with 1st gear and no other gear are typically clutch problems. With that in mind, I do have to do a brake/clutch fluid flush very soon. My inspection place here in PA said it looks like it's never been changed and it's like syrup almost. I plan on doing a complete flush with some new fluid and flush the clutch slave cylinder too. Anyone think this is worth a shot or is my transmission most-likely:confused: shot? |
Quote:
My tranny used to pop out of 2nd or 3rd when it was rainy. At the time, it was replaced under warranty. http://www.318ti.org/forum/showthread.php?t=13377 http://www.318ti.org/forum/showthread.php?t=2537 http://www.318ti.org/forum/showthread.php?t=6713 |
Well definitely flush your brake (clutch) fluid. That's just normal maintenance. Looks like you've done all you can with the shift bushings, and you've seen the bulletin. I think it's just shot. |
Thanks for your input guys. I ordered the Brake Pressure Bleeder from BavAuto but they're back ordered so hopefully they can get it out soon. |
I've always been curious with this issue. If you were to hold the gear lever in first as you release the clutch, would it stay in gear? |
Nah - forces it back out. |
it might be the gear synchro for first gear, I knew someone with a Saturn that had the same problem and that was what was wrong, although I think it was just when he downshifted |
i'd say worn synchro. I've got one in third. Pops out 30% of the time as the engine rpm drops from below 3500. |
Just ordered a new clutch slave cylinder from AutoHausAZ. I got the Brake Pressure Bleeder from BavAuto but it was the catch bottle that was back ordered. Whenever I get the clutch slave cylinder I'll do the flush and update you guys on the status of the problem. |
Update Clutch slave cylinder came yesterday. Gotta take care of a leaky valve cover gasket on my 528i tonight and if I have time (and energy) - I'll tackle the job on the Ti and provide some updates. |
Dang! No luck. Swapped out the clutch slave cylinder, bled the clutch system but no good. Clutch feels MUCH better, lighter and engages much earlier. There is a lot less resistance in every gear change too. Nevertheless, this didn't resolve my 1st gear popping. It's still popping out about 50% of the time. So to date, I've: Drained and filled the gearbox w/Royal Purple Synchromesh Installed new transmission mounts Installed all new shift bushings using the Pelican Parts rebuild kit Installed new [Febi/Bilstein] clutch slave cylinder and bled the entire brake and clutch system using ATE SL DOT4 fluid. So my only conclusion is that it is either the clutch or transmission. I'm leaning heavily toward the transmission as the clutch itself feels great in all other gears. At this point I think I'm willing to live with it but does anyone else have any other ideas? |
Well, I bought this Civic one time, in the Marines, for $200...only problem was the synchro was bad for 2nd gear. If I would accelerate, it would stay in gear, but as soon as i let off the gas, it would pop out. |
bump for this guy i'm having the exact same issue. if i can find a fix then i'll just fix the tranny and sell it. that way i can finish up my zf replacement. |
I had this very problem back when the car was 150K miles young. The fix was a new-to-me transmission. |
All times are GMT +1. The time now is 11:49 AM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org