318ti.org forum - CO M44 DASC + extras

I have a used M44 DASC Superchager kit for sale. I bought the kit used from bimmerforums a few years back. I think it had about 20k miles on it. I started making sure I had all the parts and started gathering any additional things I should replace while in there. I never got to install it. We are working on getting new cars so this won't be getting installed.

-M44 (96-99) that was on a 318ti. You will have to find out if it fits a sedan or an E30.
-What I believe is the full kit minus one 45-degree bend on the intake and the MAF brackets that support the intake. You can run without them or use something to brace it if you want. It's not needed according to downing.
-Extra fuel rail and injectors that can be sent to get cleaned a head of time
-boost gauge with pod/hoses
-new manifold gaskets
-new prelude air filter. Use this instead of the K&N so you can run a proper paper filter
-coolant hoses that attach to the block that always break anyways
-new accessory pullys
-new gatorback belt
-a few new pieces from DASC
-all new hoses
-check valve that adds about .5psi
-new hardware
-extra TB, I believe a M3 one
-air filter heat shield

I also have the install manual and parts list from DASC on .pdf.

$2,500 Local only for now, Denver CO

Autometer gauge pod for a Ti/Autometer boost gauge lines/Manifold gasket/Gatorback belt/New EGR relocation block
https://lh3.googleusercontent.com/-X...D7K_1974-1.jpg

Supercharger/Manifold/Elbow/Misc stuff already attached. Save install time!
https://lh3.googleusercontent.com/-m...D7K_1976-3.jpg

New hardware from fastenal and new pulley kits
https://lh5.googleusercontent.com/-i...D7K_1980-7.jpg

New hoses. You will have to cut to length most of the hoses. I added up the BOM and bought what I needed. Comes with the used hoses as well. Lots of hoses!
https://lh3.googleusercontent.com/-W...D7K_1983-9.jpg

Heat shield
https://lh6.googleusercontent.com/-A...7K_1984-10.jpg

Pulley brackets/New coolant pipes/boost gauge/ERG/RRFPR/Charger bracket/TB/TB cable/Fuel rail/Injectors/Check valve
https://lh4.googleusercontent.com/-H...7K_1986-11.jpg