gah, I keep screwing up the smiley codes between this forum and the other one I'm on :redface:

I went and checked on my ti in storage, put some mousetraps in the interior just in case

put a m-tech spoiler on today
my Ti needs a right good clean
http://i6.photobucket.com/albums/y20...oilerimage.jpg

that looks perfect! right click save

Pulled my worn out Ireland Engineering urethane bushings, and installed some bad ass new Vorshlag competition motormounts..

Will fab up a heat shield for them tonight once I'm done at work. Getting ready for a four day track event this weekend.

Today I took off the 17s, put the 16s back on, and removed the front bumper and grill. Preparing it to be worked on again

Removed the lower intake manifold. And then ran into Spidertri at the dealer parts counter, who's doing the same thing I am....:biggrin:

you two have been hiding from me

Not intentionally. I had to drive my wife to her office today (since it's her ti is spread out all over the garage), and Russel was only half a mile down the street I went there for parts. If I'd had more time I would have come out your way- Russel had very little in stock. They say they'll have the lot in tomorrow morning. We'll see....

s'all good partner

fix a flat tire :( (stupid nail) cost me $18

recieved my tail lights from FRED and painted them black before putting them up. they look good pics tomorrow afternoon once i get this work situation, school, and helping my uncle out the way.

every time i went out to smoke last night i smiled at my tails :P

http://i47.photobucket.com/albums/f1...13-0727jpg.jpg

http://i47.photobucket.com/albums/f1...00113-0727.jpg

http://i47.photobucket.com/albums/f1...13-0726jpg.jpg

these pictures do no justice... i personally think they look good. only lights id prefer to this would be euros..

and yes i know i need a rear wiper blade.. but im taking the motor and arm off this week more than likely.

washed and chrome exhaust tip installed.:) http://img.photobucket.com/albums/v4...i/DSC04490.jpg

Put road tax on it which cost £104.50 for 6 months.What do you mean by 'Euros' style rear lights?

Removed broken valve cover bolt
Removed and replaced plastic water pipe on block.
Replaced valve cover- it's painted black now, looks spiffy.
Reinstalled lower intake manifold, new gasket.
Reattached electrical 'squid'- oil pressure sensor, coolant temp sensor, DISA controller, alternator, starter, cam pos sensor, crank pos sensor.
Cleaned fuel injectors, replaced upper and lower O-rings.
Reinstalled fuel rail, with new supply line gasket and return line hose.
Reinstalled plug wires and coil.

It looks like an engine again....