Rear wiper problems - need part
 

I just got my car back from getting repaired (I was rear-ended) and they replaced my rear wiper. But, they told me that they couldnt source a small white 90 degree plastic part that connects to the wiper blade.

Anyone have any ideas on what this is?

Ok, I think I have found it on RealOEM but can anyone find the time to take a picture of it. All you would need to do is pop up the rear flap on the wiper and take a picture of it item. But dont touch it, its fragile!

Thanks ti people!

http://i272.photobucket.com/albums/j...k/100_0662.jpg

the one here attached to the rubber hose? it's for the washer fluid for the rear wiper

That looks like something that could be "MacGyver-ed" if you can't get a replacement.

Thanks tiFreak! But...I have that little black part. Its the part that the black part snaps into. I was told it was white and plastic. Hummm...there is an abandoned ti near my house. I may run over there and take a look.

Thanks again for the picture.

Based on the wiper blade & motor that I have in my hand, and the diagram on realoem.com, I don't think there's any white plastic part there. Perhaps they meant somewhere else along that particular hose run?

I know exactly what you are talking about. it's the nipple that that black L shaped hose snaps onto. It's fragile, and a part of the wiper motor. I broke mine when removing the rear wiper, so I had to replace the whole motor from a junk yard ti.

yup, you're gonna need a new wiper motor, if you want to snag the part of the abandoned ti it's a 14mm for the wiper nut and 3 10mm bolts behind, work fast so the cops don't catch you ;)

*disclaimer: you didn't hear it from me :drdodgy: