Parting: 1995 M42 Engine & 5 Speed & all accesseries
 

Since it doesn't look like I can practically give away the engine tranny combination (presumably due to geographic location), I'm going to solicit interest in parting it. If I can get commitments for a reasonable number of parts, I'll start tearing it apart tomorrow.

I think the prices are reasonable, but would be willing to negotiate on bundles, as I really hate going to the post office to ship a $20 part. I will attempt to ship every 2 days or so (I'm not Pelican Parts, so 1-2 but not guaranteed).

All prices plus shipping from 33813 Lakeland, FL). Paypal payment only

Engine had 130k on it, ran strong, no codes, was may daily driver, before M52 swap. All parts labelled as new, have less than 2,000 miles on them, as they would be replacements such I purchased the car in July, 2013.

Newly Replaced:
Engine & Tranny Mounts $40
Reconditioned and Flow Matched Injectors $40
Idler Pulleys x 3, plus belts $40
Water Pump & Thermostat $30


Used:
MAF and good elbow (was sold to me as rebuilt) $50
ICV with new vac hoses $40
Manual Tranny Wiring Harness / No Cuts $50
DME $50
Alternator $50
Power Steering Pump $50
AC Compressor $50
Electric Two Speed Puller (both speeds work) $60
Electric Two Speed Puller Fan (bad low speed) $25
Head (will be heavy to ship) $100
Short Block (won't ship) $100
Coil & Wires $50
Throttle Body $30
Upper & Lower Intake $40
Throttle Body $30
OBDI Sensors (Cam, Crank, Knock, Coolant Temp) $40
- Presume the knocks will be cracked and only useful as a back-up
Exhaust Manifold (Short length of cat pipe still attached) $40
Fuel Rail $20
Air Box (unmodified) - Steve has first right of refusal if he wants it $50
Radiator & Overflow Bottle $50

Tranny Bits:
5 Speed Getrag Tranny, Clutch, Flywheel, Shifter, Manual Tranny Driveshaft
- Would really prefer not to ship $250

Exhaust:
I still have the Borla Supersprint Exhaust listed previously. $150, no shipping

Works for me. :)

Steve - Anything else on the list interest you?

Nothing that I can think of. Thanks.

Can you post some pictures of the exhaust?

Ed - Exhaust Pics are in this thread. Come and get it along with anything else you might need.

http://www.318ti.org/forum/showthread.php?t=39663

The exhaust is a little to rough for my purpose but tell me more about those injectors. Are they the style with the vacuum tube going to them?

I still have the injectors. I am honestly stalling a bit trying to find a buyer for the whole engine. The injectors are the type that have the connection to bleed in air from the ICV. They were rebuilt and tested from danoperformance.

Understood. If you don't, let me know. How many miles since rebuild?

Less than a 1000. I will include the bench test report that Dan sent me with the injectors.

Perfect. I'm in if you do not sell the engine complete. You can send me a paypal invoice at bimmerbum@hotmail.com

Sold (cheap) the engine assembly locally this morning. Back to getting all 3 cars into the 3 car garage, that will make the misses happy!

spark plug wires?

As per above, I sold the entire assembly.