DASC Install Help!!
 

I am looking for the curved rubber boot to connect the ASC to the cone filter for the DASC kit I am trying to install.

There is a nice looking part in the install shown in the Notebook DASC Custom install article by Gerry Doiron and Hugo Villanueva

http://www.318ti.org/notebook/dasc/installed.htm

but I do not know where this came from.

The kit I bought was used and was still on the car but it was missing the DA aluminum intake elbow from the kit.

I need to leave the ASC in place since the ti is driven daily by my Wife so I would prefer to leave it in place...

Thanks in advance for help locating this part.

if you are talking about the small circular 45 degree elbow, i have one i dont need

Nick,

Thanks very much for the help.

The part I was referring to is the one in photo 006 with the red plug in it but if you have an elbow you think may work, I'd sure like to try it.

I can shoot you some cash via PayPal to ship it along with my address just PM me your Email address for PayPal and what you think it would take to cover the cost.

Thanks, Steve

Nick,

I completed the install on Saturday and the stock rubber boot fits like a glove in my configuration so no need for a different elbow.

Thanks for the offer in any case.

Steve