m44 parts/accesories,aligned ews, axles, tranny, etc. cheap!!! i have some m44 parts and other random parts from a part out i did a while back. all priced to sell and SHIPPING INCLUDED! m44 complete intake manifold $65 steering column w/key $50 matching ecu/ews/key chip $100! starter $45 feul lines $25 e36 auto tranny cooler and lines $45 e36 bumper shocks $25 318ti axles $75! auto transmission and torque convertor $250 --will drive 2-3 hours from northeast louisiana to meet someone for $50 extra all parts came from a 97 318ti with ~140k miles. http://i68.photobucket.com/albums/i3...ngcolumn-1.jpg http://i68.photobucket.com/albums/i3...44intake-1.jpg http://i68.photobucket.com/albums/i3...lesbshocks.jpg http://i68.photobucket.com/albums/i3...tanscooler.jpg |
forgive my ignorance but is that the engine wiring harness connected to the ECU and EWS? Do you have the engine wiring harness available and what condition may it be in? Thanks. |
the engine wiring harness is connected to the ecu and auto transmission control module. those are the two metal boxes. the ews is under the dashboard. if you only want to change the harness and keep your ecu you wont need an ews alignment and you shouldnt have any issues. wiring harness has only one flaw, rear o2 sensor is wired directly in because the clip was obviously ripped off by previous owner. shouldnt be an issue and works fine, just a little more hassle to change the sensor but no big deal. ill sell the harness alone for $55 shipped. doesnt do me too much good to have just an ecu other than that i still have a full aligned ews system. no one needs those for 4 cylinder motors really tho.. pm me if you want it and ill send you my paypal username. thanks ian |
pm sent |
Do you have a key to go with the EWS and ECU if so I will take it. If not the key maybe just the chip in the key so the ecu will work. Let me know and I will pay immediately. Thanks, John S |
i do have the key, ignition(which i cant get out of the steering column for anything!), ews amd ecu, all matching. if you can jus swap the chip in the key and dont need the whole steering column then ill sell you a master key to pull the chip out of and the ecu,ews for $80 as that would save me a lot on shipping. thanks ian |
Quote:
|
i buy, build, and chop up cars like legos. haha. mostly 318ti's.ive had four so far and im only 19. i always have a house full of what my gf calls "junk", which is really lots of valuable car parts. atleast when my beloved ti breaks down i have plenty of spare parts. :). one of these days ill get my hands on a wrecked 328i..... |
Deleted |
Hey is the DME with the chip and ews from a manual or auto 318? |
ews system from an auto 318. im not sure if the DME is any different in the manual since the auto has its seperate tranny controller.. but im not positive.. |
I wish I knew for sure. If it is the same I would most likely take it. |
bump |
All times are GMT +1. The time now is 06:44 AM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org