Clean rear seat delete im sure people have done this before and i did search in the forums for an existing thread on this and couldnt find anything. I've decided not to put the rear seats back in after the swap, and am in the process of creating a false floor for the rear out of wood and marine carpet spanning from the rear seat pan all the way to the trunk. I am doing this in order to give it a clean, stockish look. The biggest problem i have is with the outside back seat bolsters themselves. Leaving these on will look ameturish and taking them off looks rough. Could anybody post some pictures of solutions so i can get an idea of what i should be trying.....or just a picture of a clean rear seat delete at all? thanks in advance guys |
I don't think I've seen a clean rear seat delete. I've seen plenty of ti's with no seat but never one with a custom piece. I really wanna see this. Keep us updated with pics and all! Sent from my iPhone using Tapatalk |
Quote:
|
This is the best one I have ever seen, made by Iding Power. http://farm7.static.flickr.com/6100/...bfa925b2_b.jpg |
I use a template tool and make the floor in 2 pieces (lengthwise). Once you get a good fit you can push each piece tight against the side and then mark them for the center cut. On the last one I did I used split black hose to trim the edges where the floor meets the side panels. Best would be if you can figure out a ledger for the floor to rest on and be screwed to but that may be difficult because of the soft panels... |
Quote:
|
Quote:
|
1 Attachment(s) Quote:
Also, it was over 4' wide behind the wheel wells and 5' long so it had to be 2 pieces. This one is in a Mazda 323 work beater |
Quote:
|
I used a building laser to set the heights but a level works too; just find the spot that's the highest or where you want the floor to be and start there. The supports are just 3/16 flat bar bent into a "C" with "feet" which are drilled and rivetted to the floor pan They were roughly laid out and riveted down; the ply positioned and laid on top of them and holes drilled through both; got a few extra holes in the ply :):) 10-24 rivnut into the FB, countersink the flat head screws and done At first I tried to do a one piece but I couldn't get all the edges to fit tight; the template tool has to stay at right angles to the centerline of the car.....sorta I overlapped the ply a bit in the middle; snapped a chalk line down the center and drilled a 1/8th hole on the line at each end so the bottom piece was marked as well. I used a butchered pick-up canopy latch minus the handle for the spare tire lid... I think I ended up with a drum effect too; car seemed louder |
All times are GMT +1. The time now is 07:28 AM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org