**318ti Cupholders**
 

Does anyone who has past experience with the Ti center console know if this cup holder mount will fit with my set up?
http://uploads.tapatalk-cdn.com/2016...eec4f47340.jpghttp://uploads.tapatalk-cdn.com/2016...f2bbcbe95b.jpghttp://uploads.tapatalk-cdn.com/2016...d71765145a.png
Thanks for reading!


Sent from my iPhone using Tapatalk

Yes with very slight modification to the coin end but the rest drops in place. I have the same set up.


Sent from my iPhone using Tapatalk

Will your armrest be for sale? If so, I would be very interested!

What all modifications did you have to do?


Sent from my iPhone using Tapatalk

I'll try to be keeping it, but if it becomes an annoyance, and I want to get rid of it youll be first to know!


Sent from my iPhone using Tapatalk

Great news! But what modifications did you have to do?


Sent from my iPhone using Tapatalk

http://uploads.tapatalk-cdn.com/2016...a6f0b662b2.jpg

If you are putting the cup holder into existing tray it will sit just on top of shifter trim , so you have to cut the corners under the coin holder so it sits flush


Sent from my iPhone using Tapatalk

http://uploads.tapatalk-cdn.com/2016...d178f6cd2f.jpg


Sent from my iPhone using Tapatalk

A little time and material and it comes out good I don't have pic of finished but this should help


Sent from my iPhone using Tapatalk

Looks great! I was going to be pretty bummed out if I ordered this thing and it didn't even fit haha
How is the use of the arm rest? Does it get in the way with both cup holders?


Sent from my iPhone using Tapatalk

Depending on cup size you may have to put arm rest up but most fit under arm rest.


Sent from my iPhone using Tapatalk

Front cup holder not obstructed only rear or p/s


Sent from my iPhone using Tapatalk

Awesome! I appreciate your help man, I'll be doing an update in a couple days when I get it on to show the work I had to do to make it fit. In case anyone else runs into the same issue


Sent from my iPhone using Tapatalk

And one more question, is the picture on top how it's supposed to look with the correct set up? Or is that how you had it looking when you finished


Sent from my iPhone using Tapatalk

That's before I finished covering the gaps , they didn't bother me at first but then I use some plastic and cut to fit the gaps. I work for Bmw so I had some input and suggestions fellow service employees


Sent from my iPhone using Tapatalk