Cat-back exhaust w/ Magnaflow stainless muffler
 

This had just been installed on my car when I bought it from the PO. Drove around with it for about a year and realized that it was just a little too loud for me (it is a free flowing exhaust, after all) at freeway speed, so I replaced it with an OEM Eberspacher cat-back. It's set up for a 318ti, but will need to either be welded directly to the back of the cat, or have a flange welded on to make it a true bolt-on to a stock system. I would prefer to sell it locally, as shipping this will probably not be cheap or convenient.

Magnaflow stainless muffler w/ 3.5" O.D. stainless round tip (fits perfectly into stock bumper cutout); free-flow resonator; 2.25" pipe and inlet... pipe has correct crimp/bend to clear the axle (see photo). SOLD!

PM or email me with additional questions or to set an appt. to come pick it up!


http://i57.photobucket.com/albums/g2...c/P1080275.jpg

http://i57.photobucket.com/albums/g2...c/P1080280.jpg

http://i57.photobucket.com/albums/g2...c/P1080277.jpg

http://i57.photobucket.com/albums/g2...c/P1080278.jpg

http://i57.photobucket.com/albums/g2...c/P1080279.jpg

Pm'ed

bump

SOLD!