s50b28 Swap NO START??? KEY reprogram??? Ok so i finally swapped my "S50b28" into my ti today but no crank at all.. So i realized the key has to be programmed with the ecu...BUt how can i do it without going to the shop or dealer???? PLEASE HELP!!!!! |
if it has EWS system which i think it does just swap out the antenna (its a black box) where the steering column is and there should be another white box labeled EWS under the glove box with the ones that came with the motor ... put the chip from the motor into your key. that should resolve your issue. as long as all the grounds and power sources are connected correctly... |
s50b28....sounds like a custom setup. Are you OBDI or II? If one, what dme, if two, what dme? If two, get it flashed, if one, use a red labeled dme with corresponding chip, cut ews wire, if starter doesnt engage, bypass ews with large black with yellow strip and black with green strip at EWS box location, it WILL at least turn the starter over. |
post pictures too |
Quote:
**** you could also push/disconnect wire number 62 from the dme connector end but its easier to do it from the connector port attached to the fuse box**** |
I think he scrapped the project and parted out the car: http://www.318ti.org/forum/showthrea...150#post301150 |
shame |
All times are GMT +1. The time now is 07:27 AM. |
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org