M44, m42, lots of other parts
 

I have one m44, all parts are still on it and and fully assembled. Harness is hacked, used mainly for my ls1 swap. Engine does not run, not sure why. I sold it to a guy in cleveland, he had a third part install it, it hasnt run since. I bought the 1996 318ti sport auto from kentucky and drove it home, and to work for a while, then swapped in a m50NV, than sat the engine on a pallet in the garage until it was sold. Now its back and sitting on that same pallet.

I now also have an m42, it came from my 95 clubsport manual. It had 202k on it when i bought it and i put another 14 or so on it, and at its last oil change, that same day, it developed a knock. Was removed for a M50TU. It has new plugs, 8mm magnecores, and everything else still attached. I have a custom exhaust made for this engine, 2" all the way back, one cat, one muffler, one tip.

My garage is literally FILLED with parts from 1995-1998 318tis, lot of interior small pieces, couple rack and pinions, lots of rotors ///M as well, calipers, black dash, and a bunch of other stuff, let me know what you need, as im seriously contemplating calling my coworker to come haul it all away in his garbage truck.

Thanks
Tony

Glovebox handle?

no

trunk shocks?

Get new ones, mine are scrapworthy

rear rotors? if so how much? -thanks

Ill check the stash and see if i still have a pair. I know i had some cross drilled zimmermans, but not sure if i kept them or threw them out.

What would you take for the head on the M44?

Also interested in the m44 head or whole motor if the above member passes, so second in line....

100 PLUS ACTUAL SHIPPING FOR THE HEAD. 200 PLUS SHIPPING FOR THE WHOLE ENGINE.

WHere in ohio are you located?

Um, check the location bar.....

Okay, Im new on here and didnt notice the zip code thing, my bad. Im in Pitt so a little too far of a drive. Let me know a quote shipped to 16127??? I would prefer the paypal if ok.

how much for the black dash? it includes the knee panel things ? and glovebox ?

No glove box, but i may have an extra knee panel, not too sure, but if not, the dash is mint, planned to use it for a project. 75$ plus shipping