Forum: Engine 04-12-2014, 05:17 PM |
Replies: 2 Views: 1,467 Ok so I've been messing with it again. If i get... Ok so I've been messing with it again. If i get it warm it will stay running. No haveing to keep my foot on the gas pedal. But when I drive it at high rpms it loses power and starts to hesitate. Any... |
Forum: Engine 03-18-2014, 02:57 PM |
Replies: 2 Views: 1,467 95 318ti m42 5 speed stalling/ running rough Well I've decided to take another whack at getting this car running right...I've done everything I can think from replace the fuel pump to spark plugs, even the dme...car just starts up runs fine for... |
Forum: Engine 12-08-2013, 10:52 PM |
Replies: 10 Views: 1,948 |
Forum: Engine 12-06-2013, 07:57 AM |
Replies: 10 Views: 1,948 |
Forum: Engine 12-05-2013, 10:23 PM |
Replies: 10 Views: 1,948 |
Forum: Engine 12-05-2013, 03:54 PM |
Replies: 10 Views: 1,948 I need help finding a DME Ok so I have a 95 318ti I got it running and it drives and I've replaced enough parts as it has new fuel pump, plugs, wires, coil, fuel filter I've checked everything I could until I took it to a... |
Forum: Northwestern - US 11-26-2013, 09:30 PM |
Replies: 70 Views: 70,251 |
Forum: Lounge 11-07-2013, 01:50 AM |
Replies: 3,226 Views: 577,182 |
Forum: Engine 11-07-2013, 01:45 AM |
Replies: 5 Views: 1,365 |
Forum: Engine 11-06-2013, 11:07 PM |
Replies: 7 Views: 3,132 Ok so I jumped the fan switch and it works on... Ok so I jumped the fan switch and it works on both high and low speed so I baught a new switch...it don't come on with Ac at all...I drove it after letting it idle for 10-20 min and it never went... |
Forum: Engine 11-06-2013, 02:15 AM |
Replies: 7 Views: 3,132 |
Forum: Electrical 11-05-2013, 03:35 AM |
Replies: 22 Views: 11,993 |
Forum: Engine 11-04-2013, 04:10 PM |
Replies: 7 Views: 3,132 |
Forum: Parting out & Parts (US) 11-04-2013, 04:06 PM |
Replies: 1 Views: 2,532 |
Forum: US and North America 11-03-2013, 02:44 AM |
Replies: 12 Views: 1,654 |
Forum: US and North America 11-03-2013, 02:39 AM |
Replies: 12 Views: 1,654 WTB: A Set of Brake Lines If you can get away with the copper lines I say run copper lines...if mine rust out I'm going to replace the master cylinder and run -3 SS LINES thru the whole car...can you say super stiff brakes |
Forum: US and North America 11-02-2013, 02:15 PM |
Replies: 12 Views: 1,654 |
Forum: US and North America 11-01-2013, 07:55 PM |
Replies: 12 Views: 1,654 |
Forum: Engine 10-31-2013, 08:01 PM |
Replies: 7 Views: 3,132 |
Forum: US and North America 10-30-2013, 09:42 PM |
Replies: 12 Views: 1,654 |
Forum: Lounge 10-30-2013, 03:49 PM |
Replies: 2,264 Views: 774,066 |
Forum: Parting out & Parts (US) 10-30-2013, 03:32 PM |
Replies: 1 Views: 2,532 Used never ran clutch for dual mass flywheel I have a clutch I baught a yr or 2 ago I installed it in my 318ti backwards due to improper labeling on the clutch disk...I pulled it and baught another oem clutch from the dealer and after comparing... |
Forum: Engine 10-30-2013, 02:13 PM |
Replies: 7 Views: 3,132 |
Forum: Parting out & Parts (US) 10-29-2013, 07:12 PM |
Replies: 9 Views: 3,316 |
Forum: eBay and Craig's list listings 10-29-2013, 05:17 PM |
Replies: 6 Views: 1,754 |