Forum: Engine  08-09-2010, 09:16 PM |
| Replies: 8 Views: 4,530  Think I found the problem
Well, while checking the starter the braided copper wire that goes into the starter came off when I tried to wiggle it with my finger. I guess that must be my problem.
Thus I need to either get a... |
| Forum: Engine 08-09-2010, 08:33 PM |
| Replies: 8 Views: 4,530 |
| Forum: Engine 08-09-2010, 03:14 PM |
| Replies: 8 Views: 4,530 The car is a 1995 and 5 speed. I checked the...
The car is a 1995 and 5 speed. I checked the fuses again over the weekend but nothing seemed to be blown. Is there another fuse that I might be missing in a spot I do not know about? I was out of... |
| Forum: Engine 08-05-2010, 05:55 PM |
| Replies: 8 Views: 4,530 Engine will not start -- where do I start?
I was driving my car today. Parked it; then came out to start it. Radio playing, windows worked, key was even beeping. However, when I turned the key over there was nothing. Turned everything off... |
| Forum: Engine 03-29-2008, 11:55 PM |
| Replies: 3 Views: 2,920 ODB1 Reset
I read the Error code write up and was able to read the error codes... although it seemed to keep repeating the same code for, let say, 15 times before I stop reading them. I did not see a procedure... |
| Forum: Knowledge Base 03-25-2008, 05:13 PM |
| Replies: 58 Views: 75,427 micro filter cleaning
I also did not want to spend $40 for new filters so I used hot water and a strong batch of Oxyclean to wash them after I gently removed all the really big stuff. The water was black after the first... |
| Forum: Engine 03-25-2008, 02:46 PM |
| Replies: 2 Views: 912 Engine Searching
I have a 1995 Ti with 110K mile on it and just recently it has some new habits. I live in Michigan where it is still cold and in the morning the car starts right up but has a hard time idling and... |
| Forum: Maintenance 07-17-2007, 05:16 AM |
| Replies: 4 Views: 1,151 I am not sure where to enter the 10 mm hex...
I am not sure where to enter the 10 mm hex wrench. I did not see anything that size. I was able to move the longer belt by using a very large screwdriver and forcing it against the metal block on... |
| Forum: Maintenance 07-17-2007, 03:08 AM |
| Replies: 5 Views: 5,513 |
| Forum: Maintenance 07-17-2007, 02:42 AM |
| Replies: 4 Views: 1,151 Air conditioner belt tention
I need to change both of my belts on my 318ti and have figured out how to get the longer belt free but can not determine how to loosen the air conditioning belt. I have loosened the bolt that looks... |
| Forum: Maintenance 07-17-2007, 02:39 AM |
| Replies: 5 Views: 5,513 reset oil change
I once pulled down a procedure for clearing the oil change light on my 318ti using pin 19 and another, a wire and two jump terminals but I can not find the procedure since my last oil change. Does... |
