318ti.org forum

Go Back   318ti.org forum > Search Forums
Reload this Page Search Results
Register FAQ Donate Calendar Today's Posts Search

Notices

.
Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: Switters959
Forum: Engine 12-31-2011, 08:58 AM
Replies: 10
Views: 4,326
Posted By Switters959
OK' pulled the upper intake off and oops, one of...

OK' pulled the upper intake off and oops, one of the sensor leads had come unclipped. I pushed it back on and installed new clip, now it idles very erratically. It goes from 600 to 1200 and back in...
Forum: US and North America 12-23-2011, 10:14 PM
Replies: 0
Views: 564
Posted By Switters959
95 318ti m42 project / parts

I just replaced the head gasket, wouldn't start, sensors out so I put new cam and crank, started and ran, next day no start, now code for 02 sensor. Also the ignition spinning problem. Front end...
Forum: Engine 12-22-2011, 08:00 AM
Replies: 10
Views: 4,326
Posted By Switters959
Yea, one of the lines. I can't win with this...

Yea, one of the lines. I can't win with this car. I fixed (mostly) the idle problem, decided to drive the car the 1 mile to work and the key just spun in the lock cylinder when I tried to turn it...
Forum: Engine 12-21-2011, 08:32 PM
Replies: 10
Views: 4,326
Posted By Switters959
Well, I ordered new crank and cam sensors, went...

Well, I ordered new crank and cam sensors, went to put them on and noticed that I pulled the crank sensor connector out will tugging on the intake housing getting the heads off. I went ahead and...
Forum: Engine 12-19-2011, 12:31 AM
Replies: 10
Views: 4,326
Posted By Switters959
Both sprockets are marked with an arrow so they...

Both sprockets are marked with an arrow so they went on right ( I marked the chains with silicone at the arrows to match them up). So I am sure it would hit the right timing point. This is the 3rd...
Forum: Engine 12-18-2011, 11:08 PM
Replies: 10
Views: 4,326
Posted By Switters959
Just a thought, are the camshaft sprockets...

Just a thought, are the camshaft sprockets interchangeable? They look the same and match up, I was wondering if one of "studs" on the sprocket was designed to trip the position sensor and the other...
Forum: Engine 12-18-2011, 10:25 PM
Replies: 23
Views: 8,678
Posted By Switters959
No lower cover

Thats the timing chain cover. There are two metal gaskets and a bottom thick rubber one. There are also 2 metal gaskets on the inside to separate the chain area from the water inlet housing. Those...
Forum: Engine 12-18-2011, 10:16 PM
Replies: 10
Views: 4,326
Posted By Switters959
Question m42 no spark and no fuel

1995 m42 1.8. So I've read a few posts with this problem. Mine is FUN-Key. I replaced the head gasket, put it back together and it wouldn't start. I pulled the #3 plug and tested it for spark and...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT +1. The time now is 12:06 AM.

Donate - Contact Us - www.318ti.org - Archive - Top

.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 42.63 k/49.16 k (13.29%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.