318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 25 of 55
Search took 0.00 seconds.
Search: Posts Made By: speedracerf4i
Forum: Electrical 04-19-2012, 04:05 PM
Replies: 12
Views: 5,110
Posted By speedracerf4i
Reseting the OBD after oil change

The smog tech is right. Once you reset your OBD, then you need at leat 150 miles to accumulate new data to satisfy the smog tester computer. This is to prevent people from just resetting their bad...
Forum: Electrical 03-23-2011, 03:52 PM
Replies: 12
Views: 5,110
Posted By speedracerf4i
I found the cause of my failed connection. I...

I found the cause of my failed connection.

I had reset the oil indicator the previous night, and forgot to twist tight the 20 pin connector lid under the hood. After tightening the cap, I was able...
Forum: Electrical 03-18-2011, 04:24 AM
Replies: 12
Views: 5,110
Posted By speedracerf4i
My car failed the smog test 2 weeks ago due to a...

My car failed the smog test 2 weeks ago due to a crack on the intake boot. The hole is after the MAF so the unmetered air was being sucked in causing the engine to run lean.

I replaced the leaky...
Forum: Lounge 12-04-2009, 08:27 PM
Replies: 6
Views: 4,321
Posted By speedracerf4i
Don't use fork

Don't waste your time using a fork. I tried in vain to separate the ball joint using a fork. Buy a ball joint separator instead. It will save you time and do less damage to the wheel spindle.
...
Forum: Electrical 02-17-2009, 11:03 PM
Replies: 3
Views: 1,437
Posted By speedracerf4i
My problem has been resolved!! It was my...

My problem has been resolved!!

It was my catalytic converter that was constipated.

Thanks for all your replies.
Forum: Engine 02-17-2009, 07:29 PM
Replies: 13
Views: 2,167
Posted By speedracerf4i
My mystery has been solved! I finally towed...

My mystery has been solved!

I finally towed my car to a shop and after going over all the possible causes and came up fine.

The problem, as it turn out, was constipation. My catalytic converter...
Forum: Engine 02-17-2009, 07:01 PM
Replies: 21
Views: 6,464
Posted By speedracerf4i
My mystery has been solved! I finally towed...

My mystery has been solved!

I finally towed my car to a shop and after going over all the possible causes and came up fine.

The problem, as it turn out, was constipation. My catalytic converter...
Forum: Electrical 02-17-2009, 06:09 PM
Replies: 3
Views: 1,437
Posted By speedracerf4i
Can I use DME from auto with my manual?

I have a 98 sport manual with possible DME problem.

I found a member with a good DME, but the part comes from a 98 auto.

I searched realOEM but there are just so many part numbers for the DME...
Forum: US and North America 02-16-2009, 03:56 AM
Replies: 123
Views: 25,299
Posted By speedracerf4i
Do you have the DME? How much. Thanks

Do you have the DME? How much.

Thanks
Forum: Engine 02-11-2009, 11:14 PM
Replies: 13
Views: 2,167
Posted By speedracerf4i
I tested the ignition coil with the a voltimeter...

I tested the ignition coil with the a voltimeter and found out the the resistence was between 10-14 miliohms. According to Bentley, it should be 4-8 mili-ohms. I also found hair-line cracks on my...
Forum: Engine 02-11-2009, 11:12 PM
Replies: 21
Views: 6,464
Posted By speedracerf4i
I tested the ignition coil with the a voltimeter...

I tested the ignition coil with the a voltimeter and found out the the resistence was between 10-14 miliohms. According to Bentley, it should be 4-8 mili-ohms. I also found hair-line cracks on my...
Forum: Engine 02-07-2009, 08:50 PM
Replies: 21
Views: 6,464
Posted By speedracerf4i
I just replaced the MAF I bought from Marvin. ...

I just replaced the MAF I bought from Marvin.

The car is still in Limp mode. no luck...

I will take to the shop and let them figure out what's wrong
Forum: US and North America 02-06-2009, 12:00 AM
Replies: 55
Views: 10,228
Posted By speedracerf4i
Hey Mav, I may need your MAF. gimme a...

Hey Mav,

I may need your MAF.

gimme a call 626-363-3005

Thanks

Leonard
Forum: Engine 02-05-2009, 08:39 PM
Replies: 21
Views: 6,464
Posted By speedracerf4i
OK, I narrowed it down to a bad MAF. ...

OK, I narrowed it down to a bad MAF.

According to Bently manual, a bad MAF will make your DME to go into "Limp" mode. My ignition, fuel delivery, emission, all are normal. So I am buying a used...
Forum: Engine 01-30-2009, 05:50 PM
Replies: 21
Views: 6,464
Posted By speedracerf4i
OK, I'll give it a try. I have reset the...

OK, I'll give it a try.

I have reset the "cylinder 1 misfire" and I'll drive it on my neighborhood streets some more to see if anymore codes would come up.

I have the Bently manual and I will...
Forum: Engine 01-28-2009, 11:32 PM
Replies: 21
Views: 6,464
Posted By speedracerf4i
I sprayed a fine mist of water around the intake...

I sprayed a fine mist of water around the intake boot, but there was no disturbance. So I don't think my boot was the culprit.
Forum: Engine 01-28-2009, 08:40 PM
Replies: 13
Views: 2,167
Posted By speedracerf4i
yes, cylinder 1 (furthest from the driver) and...

yes, cylinder 1 (furthest from the driver) and number 2.
Forum: Engine 01-28-2009, 08:38 PM
Replies: 13
Views: 2,167
Posted By speedracerf4i
The spark plug is 1 year old and shows no oil and...

The spark plug is 1 year old and shows no oil and no abnormal discorolation.

The is no electrical arc visible except on the tip of the plug like it should.

Thanks for the link, at least I know...
Forum: Engine 01-28-2009, 07:36 PM
Replies: 13
Views: 2,167
Posted By speedracerf4i
Wouldn't a bad MAF pull a cell? How can I...

Wouldn't a bad MAF pull a cell?

How can I check if the ICV and Crankcase vent are bad besides replacing them? My idling seems fine though.
Forum: Engine 01-28-2009, 07:23 PM
Replies: 21
Views: 6,464
Posted By speedracerf4i
My problem is as yours, but my rev limit is only...

My problem is as yours, but my rev limit is only 2K.

I was driving on the freeway yesterday and all of a sudden, I lost power (50%). The engine still runs as if I was driving in neutral. A cell...
Forum: Engine 01-28-2009, 07:10 PM
Replies: 13
Views: 2,167
Posted By speedracerf4i
Disappearing power. M44 help!!!

I have a very strange problem and hopefully you guys can tell me what to look for.

I was driving on the freeway yesterday and all of a sudden, I lost power (50%). The engine still runs as if I was...
Forum: US and North America 01-28-2009, 07:09 PM
Replies: 55
Views: 10,228
Posted By speedracerf4i
Hey Marv, Is your coil pack new? I...

Hey Marv,

Is your coil pack new?

I live in LA area and can pick up.

leo@alfaline.com

Leonard
Forum: Suspension 11-13-2008, 05:30 PM
Replies: 22
Views: 7,019
Posted By speedracerf4i
If the set included the "lollipop" bushings, then...

If the set included the "lollipop" bushings, then it's a good deal. Make sure that you use the 96-99 M3 solid rubber bushings, as it's all solid. Stock 318ti control arm bushings has gaps in the...
Forum: Suspension 11-06-2008, 01:31 AM
Replies: 22
Views: 7,019
Posted By speedracerf4i
I bought 4 new tires and 4 straight 17" contours...

I bought 4 new tires and 4 straight 17" contours and the problem persists.

I am thinking that it's the steering rack's problem, or related links.
Forum: Suspension 11-06-2008, 01:07 AM
Replies: 22
Views: 7,019
Posted By speedracerf4i
I have the same problem when I bought the car....

I have the same problem when I bought the car. After replacing all these (in order), the steering wheel still vibrate, but a lot less now.

1. Tie rod
2. control arms with m3 solid bushings and...
Showing results 1 to 25 of 55

 
Forum Jump

All times are GMT +1. The time now is 11:48 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 71.20 k/79.94 k (10.94%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.