318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 12 of 12
Search took 0.00 seconds.
Search: Posts Made By: Breeze30
Forum: Suspension 11-04-2008, 09:43 PM
Replies: 1
Views: 1,696
Posted By Breeze30
Cv joint or something else?

Hey guys, I'm getting a clicking sound from the rear while driving. It sounds like a cv joint going bad on the right side, because it increases and decrease on speed and clicks louder on takeoff or...
Forum: Exterior 06-19-2008, 10:24 PM
Replies: 0
Views: 887
Posted By Breeze30
Wiper problems

Had a problem with my wipers on my 95 ti. They would only come on when turned on high and sometimes not at all. I could here a click coming from the module behind the glove box when I changed...
Forum: HVAC 01-25-2006, 04:08 PM
Replies: 47
Views: 7,853
Posted By Breeze30
Juni, make sure the cable opens the flap on the...

Juni, make sure the cable opens the flap on the heater box all the way. My car was doing the exact same thing. bled the system what seemed like 100 times but it wasn't that. The cable from the...
Forum: Engine 01-06-2006, 06:08 AM
Replies: 5
Views: 2,300
Posted By Breeze30
Problem solved. The service guys at Suntrup BMW...

Problem solved. The service guys at Suntrup BMW in St. Louis called it my hooter valve. In case anyone else has this problem here is a review of what was happening. A very loud whine (vacuum leak)...
Forum: Engine 12-26-2005, 09:34 PM
Replies: 5
Views: 2,300
Posted By Breeze30
Great, that was fast. I took the intake manifold...

Great, that was fast. I took the intake manifold off and checked for leaks, found nothing. I cleaned out the idle control valve and it was half closed but didn't check to see if it was stuck. Thanks...
Forum: Engine 12-26-2005, 03:59 PM
Replies: 5
Views: 2,300
Posted By Breeze30
Bad vacuum leak?

My 95 ti has a real loud whistle. It is on and off, but when the engine is running, if I pull the oil dipstick, the whistle stops, put it back in and whistle starts. I can hear the air pressure...
Forum: HVAC 10-31-2005, 09:17 PM
Replies: 123
Views: 84,285
Posted By Breeze30
Correct. You have to take the glove box out of...

Correct. You have to take the glove box out of the car, its only 6 screws or so, unhook the glove box light and switch wires. Then take out the knee bolster, its only 4 10mm bolts. Then unhook the...
Forum: HVAC 10-31-2005, 07:31 PM
Replies: 123
Views: 84,285
Posted By Breeze30
Severian, you can burp the radiator by loosening...

Severian, you can burp the radiator by loosening the plastic screw at the top or the radiator next to the fill cap, start the engine and let run. You will loose some coolant so you might want to put...
Forum: Electrical 10-10-2005, 02:44 PM
Replies: 3
Views: 1,618
Posted By Breeze30
AlaskaBlue, I had the same problem with my alarm...

AlaskaBlue, I had the same problem with my alarm beeping after I set it. It turned out to be a faulty push pin switch on the hatch. The alarm beeps to tell you that one of the sensors is bad, or...
Forum: Misc 10-06-2005, 07:09 PM
Replies: 13
Views: 2,162
Posted By Breeze30
The A/M button lets you control what gear you...

The A/M button lets you control what gear you want to keep your car in. If the roads are slick (snow, ice) and you press the M button your car will not shift out of that gear. Basically it's so you...
Forum: Electrical 09-26-2005, 02:50 PM
Replies: 12
Views: 2,995
Posted By Breeze30
I had a chance to check on my car this weekend....

I had a chance to check on my car this weekend. Apparently the dash lights and radio (if I left it on) would just decide to come on when it wanted to, the car was locked, alarm on and the keys inside...
Forum: Electrical 09-22-2005, 05:10 AM
Replies: 12
Views: 2,995
Posted By Breeze30
My car has the same problem. I would check the...

My car has the same problem. I would check the terminals at the starter and see if the wire from the switch to the selenoid is hot when the ignition switch is turned. If it's hot, then it probably is...
Showing results 1 to 12 of 12

 
Forum Jump

All times are GMT +1. The time now is 07:34 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 49.06 k/56.13 k (12.59%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.