318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 17 of 17
Search took 0.00 seconds.
Search: Posts Made By: apyndo
Forum: Engine 08-10-2013, 12:19 AM
Replies: 24
Views: 2,382
Posted By apyndo
Replaced the camshaft position sensor Brandon to...

Replaced the camshaft position sensor Brandon to no avail so back to the drawing board. Haven't pulled the fuel injectors so doing that next and test relays.
Forum: Engine 08-02-2013, 03:43 AM
Replies: 24
Views: 2,382
Posted By apyndo
I bought my car under the terms of it needing a...

I bought my car under the terms of it needing a head gasket, at a shop it may cost in the thousands with the labor hours involved. The gasket or gasket kit costs about 150 bucks, you'll also need new...
Forum: Engine 08-01-2013, 10:49 PM
Replies: 24
Views: 2,382
Posted By apyndo
In order of likeliness, most likely: blown head...

In order of likeliness, most likely: blown head gasket, possibility of cracks in head, least likely: cracked engine block, it's cast iron.
Forum: Engine 07-31-2013, 01:33 AM
Replies: 24
Views: 2,382
Posted By apyndo
Alright will do, I have checked the fuel and...

Alright will do, I have checked the fuel and spark. The fuel pressure is spot on at 3 bar and the spark plugs have spark when cranking. There was an intermittent code for MAF p1140 but it hasn't came...
Forum: Engine 07-31-2013, 01:12 AM
Replies: 24
Views: 2,382
Posted By apyndo
Brandon, I checked my CPS and it read 528 on the...

Brandon, I checked my CPS and it read 528 on the mulitmeter would this be within spec ? The car has no fault codes but cranks and cranks and hardly starts.
Forum: Engine 07-22-2013, 09:11 PM
Replies: 24
Views: 2,382
Posted By apyndo
So all coolant related right ?

So all coolant related right ?
Forum: Engine 07-22-2013, 08:25 PM
Replies: 24
Views: 2,382
Posted By apyndo
What hoses and connector did they replace ?

What hoses and connector did they replace ?
Forum: Engine 07-22-2013, 05:21 PM
Replies: 24
Views: 2,382
Posted By apyndo
I do not. I need to solve the issue in order to...

I do not. I need to solve the issue in order to register it its currently off the road. When it does start it runs decent, does yours run alright when it does start ? Also do you know what hoses and...
Forum: Engine 07-22-2013, 01:04 PM
Replies: 24
Views: 2,382
Posted By apyndo
I have the same exact issue and also cannot seem...

I have the same exact issue and also cannot seem to figure out the problem.
Forum: Engine 07-19-2013, 02:29 AM
Replies: 2
Views: 906
Posted By apyndo
Is there anyway to test it besides buying a new...

Is there anyway to test it besides buying a new one ?
Forum: Engine 07-09-2013, 10:46 PM
Replies: 8
Views: 1,423
Posted By apyndo
No problem, look where the chain guide tensioner...

No problem, look where the chain guide tensioner is located, below that is the lowest point of the profile gasket
Forum: Engine 07-09-2013, 07:44 PM
Replies: 8
Views: 1,423
Posted By apyndo
There is a more extensive write up on...

There is a more extensive write up on bimmerforums that includes this but also includes chain guide replacement. You do need to remove the thermostat for this job as it is located in the middle of...
Forum: Engine 07-09-2013, 06:05 PM
Replies: 8
Views: 1,423
Posted By apyndo
It could be the profile gasket, another common...

It could be the profile gasket, another common oil leak source. I pinched mine when installing a new one and it leaked in the same exact location as yours. It requires taking the valve cover off and...
Forum: Engine 07-09-2013, 04:58 PM
Replies: 2
Views: 906
Posted By apyndo
Long cranks and only starts when depressing gas pedal

Thanks to anyone in advance, but the car is a 1997 318i and it has a hard time starting up unless you depress the gas pedal. After doing some research I believe it is either the fuel pump of fuel...
Forum: Engine 05-18-2013, 04:32 AM
Replies: 5
Views: 1,179
Posted By apyndo
That proved to be the problem, I had the wire...

That proved to be the problem, I had the wire that goes to the oil filter housing and the DISA wire mismatched. Swapped them and no check engine lights. Thank you Mr. Firestone for your help, it is...
Forum: Engine 05-17-2013, 02:00 PM
Replies: 5
Views: 1,179
Posted By apyndo
The plug had a closed off side should i be...

The plug had a closed off side should i be looking for another wire ? Is this the wrong wire in general ?
Forum: Engine 05-17-2013, 01:15 PM
Replies: 5
Views: 1,179
Posted By apyndo
97 318i DISA issue

Car is throwing p1511 code, DISA control circuit electrical. Re-did the wire connecting to the DISA as it seemed frail and dried out, did not make the code go away. Ended up removing the DISA unit...
Showing results 1 to 17 of 17

 
Forum Jump

All times are GMT +1. The time now is 10:49 AM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 56.41 k/64.15 k (12.06%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.