318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 25 of 207
Search took 0.00 seconds.
Search: Posts Made By: Estii
Forum: Maintenance 05-20-2019, 09:09 PM
Replies: 8
Views: 1,534
Posted By Estii
Replace those immediately. I dont suggest even...

Replace those immediately. I dont suggest even driving the car until those are replaced. You can blow those to peices easily and cause an overheat. Then u might even cause head damage. You cant take...
Forum: United States 03-17-2019, 10:17 PM
Replies: 0
Views: 480
Posted By Estii
Changing wheels soon, need help with tire size

Right now my Ti is on 16x8 5 series wheels. Bit im preparing to install fender flares and i will be switching to 17x8 front with spacers and 17x10 rear. Just need help figuring out what size tire...
Forum: Engine 02-27-2019, 02:24 AM
Replies: 192
Views: 85,231
Posted By Estii
Big up to barrie at midnight tuning. Anyone who...

Big up to barrie at midnight tuning. Anyone who hasnt done this tune yet needs to get it done!


Sent from my iPhone using Tapatalk
Forum: SoCal 01-07-2019, 06:12 AM
Replies: 5
Views: 2,005
Posted By Estii
Hell yea! Ill be there Sent from my...

Hell yea! Ill be there


Sent from my iPhone using Tapatalk
Forum: SoCal 01-06-2019, 07:01 AM
Replies: 5
Views: 2,005
Posted By Estii
Is this for east or west? Sent from my...

Is this for east or west?


Sent from my iPhone using Tapatalk
Forum: Engine 11-02-2018, 09:06 PM
Replies: 72
Views: 18,116
Posted By Estii
warm engine start problem.

Also the car runs really bad and has almost no power if i have the evap purge valve plugged in. So i just leave it unplugged and i have very little power under 3k rpm. Once i reach 3k or higher there...
Forum: Engine 11-02-2018, 07:23 PM
Replies: 72
Views: 18,116
Posted By Estii
warm engine start problem.

Update. Hard starts when warm has returned. After some research ive found it could be either a bad or dirty MAF, or a faulty Fuel Pressure Regulator. FPR seems to be cheaper, so once I figure out...
Forum: Electrical 10-30-2018, 09:13 PM
Replies: 6
Views: 1,634
Posted By Estii
Agreed, hope all goes well, but it is a pretty...

Agreed, hope all goes well, but it is a pretty extensive swap and costly. I think u jumped the gun a bit. Might have been better to wait until you could purchase an existing manual. The time and...
Forum: Electrical 10-30-2018, 06:42 PM
Replies: 6
Views: 1,634
Posted By Estii
http://www.midnight-tuning.com/product/e36-318iist...

http://www.midnight-tuning.com/product/e36-318iisti-performance-flash-96-99

Check with Barry, i hear hes the best.


Sent from my iPhone using Tapatalk
Forum: United States 10-30-2018, 06:40 PM
Replies: 9
Views: 1,225
Posted By Estii
Another whole day with everything running...

Another whole day with everything running perfect. Only problem im still having is the hard starting.


Sent from my iPhone using Tapatalk
Forum: United States 10-30-2018, 06:37 PM
Replies: 5
Views: 953
Posted By Estii
So figure 2, one end comes from the check valve,...

So figure 2, one end comes from the check valve, the other end goes to FPR, and the third line?
Forum: Suspension 10-30-2018, 05:41 AM
Replies: 19
Views: 2,407
Posted By Estii
There was a nice 944 at that event! Sent...

There was a nice 944 at that event!


Sent from my iPhone using Tapatalk
Forum: United States 10-30-2018, 04:24 AM
Replies: 5
Views: 953
Posted By Estii
Figure 2 is the area in question. Ill have...

Figure 2 is the area in question. Ill have another look, but i dont remember ever seeing a line on there, or seeing a disconected line lying near there. Thanks for the response
Forum: United States 10-30-2018, 02:31 AM
Replies: 5
Views: 953
Posted By Estii
Strange vac diagram

Looking at the m44 vac diagram, there is a T fitting with nothing attached on the top post. Is this correct? Thats how mine is setup too and im wondering if i have a disconnected vac...
Forum: United States 10-30-2018, 02:30 AM
Replies: 0
Views: 767
Posted By Estii
Forum: United States 10-29-2018, 08:49 PM
Replies: 9
Views: 1,225
Posted By Estii
Update: last night after the car had been sitting...

Update: last night after the car had been sitting for a good 7 hours. I decided to start it, and while at idle i unplugged the MAF. As expected the car idled terrible, and nearly stalled. But when i...
Forum: United States 10-28-2018, 08:57 PM
Replies: 9
Views: 1,225
Posted By Estii
I can give it a try. I pulled codes again this...

I can give it a try. I pulled codes again this morning and found:

P0170- fuel trim bank 1
P0335- crankshaft position sensor A circuit

I also read that a bad MAF may cause these issues. But im...
Forum: United States 10-28-2018, 09:21 AM
Replies: 9
Views: 1,225
Posted By Estii
https://youtu.be/I0TXGySg3YY Sent from my...

https://youtu.be/I0TXGySg3YY


Sent from my iPhone using Tapatalk
Forum: United States 10-28-2018, 04:55 AM
Replies: 9
Views: 1,225
Posted By Estii
https://youtu.be/c1Lb9B3c9vc Sent...

https://youtu.be/c1Lb9B3c9vc




Sent from my iPhone using Tapatalk
Forum: United States 10-28-2018, 04:54 AM
Replies: 9
Views: 1,225
Posted By Estii
https://youtu.be/NcGEHIMrErw And heres...

https://youtu.be/NcGEHIMrErw

And heres another issue. Not sure if the two are related


Sent from my iPhone using Tapatalk
Forum: United States 10-28-2018, 04:48 AM
Replies: 9
Views: 1,225
Posted By Estii
https://youtu.be/NcGEHIMrErw Heres a video...

https://youtu.be/NcGEHIMrErw

Heres a video to help depict the issue


Sent from my iPhone using Tapatalk
Forum: United States 10-28-2018, 02:43 AM
Replies: 9
Views: 1,225
Posted By Estii
Slow rpm drop to idle

Having an issue where rpm takes several seconds to fall back down to idle. It takes rough 3-5 seconds to fall from 3-4k back down to idle. I just replaced the ICV with a brand new unit today, was...
Forum: Suspension 10-25-2018, 05:05 AM
Replies: 19
Views: 2,407
Posted By Estii
If you want stiff springs and they do lower the...

If you want stiff springs and they do lower the car a bit, you can counter that with spacers. I know condor makes a spring perch spacer kit and its pretty damn cheap too.
...
Forum: Suspension 10-25-2018, 02:37 AM
Replies: 19
Views: 2,407
Posted By Estii
I see. With these BCs ive done some nasty canyon...

I see. With these BCs ive done some nasty canyon climbs, but it was entirely paved. And then brutal street use evry time I drive the car.


Sent from my iPhone using Tapatalk
Forum: Suspension 10-25-2018, 02:31 AM
Replies: 19
Views: 2,407
Posted By Estii
Destroy BCs how? These are built very very well....

Destroy BCs how? These are built very very well. Ive had mine for a good 2 years now with not 1 issue. And i have the ISC coilover covers too, to protect the threads lock rings and tubes from grime...
Showing results 1 to 25 of 207

 
Forum Jump

All times are GMT +1. The time now is 04:50 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2019, 318ti.org
[page compression: 70.32 k/79.21 k (11.22%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.