318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 25 of 451
Search took 0.01 seconds.
Search: Posts Made By: BRADESTAR
Forum: US and North America 02-11-2019, 06:56 AM
Replies: 2
Views: 452
Posted By BRADESTAR
I do have one that ends in 667. Out of a '96...

I do have one that ends in 667. Out of a '96 automatic.
Forum: US and North America 02-11-2019, 05:19 AM
Replies: 2
Views: 452
Posted By BRADESTAR
I think I have one. Will check. What year's were...

I think I have one. Will check. What year's were they in?
Forum: Cars for Sale 01-26-2019, 10:28 AM
Replies: 9
Views: 1,339
Posted By BRADESTAR
OMG! What a fantastic color! Perhaps I'm a bit...

OMG! What a fantastic color! Perhaps I'm a bit partial, but my goodness, that thing should be 3x"s the price on color alone! ...(I have a canvas top 98 in that color)

Seriously though, you don't...
Forum: Exterior 01-11-2019, 05:08 AM
Replies: 16
Views: 5,828
Posted By BRADESTAR
Yes. Just don't do as Bradestar has done. There...

Yes. Just don't do as Bradestar has done. There are a lot of torx visible there and 2 PHILLIPS screws which are not, at the front corners. I missed those screws and fought it a bit to get it out, in...
Forum: Exterior 01-10-2019, 04:32 AM
Replies: 16
Views: 5,828
Posted By BRADESTAR
I've got a few. Redoing the rubber gasket helped...

I've got a few. Redoing the rubber gasket helped out my leaky top. My hoses weren't clogged. I only used one zip tie putting them back on. I guess two is water tight (they do that on boat lines or...
Forum: Engine Swaps 01-08-2019, 05:03 AM
Replies: 9
Views: 1,057
Posted By BRADESTAR
Seems like you need the carrier and selector rod...

Seems like you need the carrier and selector rod from a 325, since those had the 6 cyl. with Getrag tranny. I mistakenly picked those pieces up thinking they were the same as 328i. But later learned...
Forum: Engine 12-20-2018, 04:12 PM
Replies: 10
Views: 1,499
Posted By BRADESTAR
Security system. Whereas DME (engine computer),...

Security system. Whereas DME (engine computer), chip in ignition key, and EWS module, all must match for car to start.

You can get those 3 things from donor or have the ews requirement coded out...
Forum: Maintenance 12-12-2018, 02:47 AM
Replies: 6
Views: 1,049
Posted By BRADESTAR
Right. Y tho? It's 2019, put the old one in...

Right. Y tho?

It's 2019, put the old one in landfill and get new belt.
Forum: Maintenance 12-12-2018, 01:31 AM
Replies: 6
Views: 1,049
Posted By BRADESTAR
I didn't even know "belt conditioner" existed....

I didn't even know "belt conditioner" existed. What the heck? Must be a thing from a bygone era?
Forum: Engine 11-27-2018, 04:08 AM
Replies: 188
Views: 80,899
Posted By BRADESTAR
Order placed. Thanks for thinking of us again! ...

Order placed. Thanks for thinking of us again!

I've been running the M44 tune for 3 years now and only have good things to say about it.....nice for us to have the option for the slight bump to...
Forum: Engine 11-26-2018, 02:33 AM
Replies: 188
Views: 80,899
Posted By BRADESTAR
Cool! Email sent..

Cool! Email sent..
Forum: Personal bios and Introductions 11-21-2018, 07:08 AM
Replies: 3
Views: 746
Posted By BRADESTAR
Cool car! Used to work in Everett. Got sick of...

Cool car! Used to work in Everett. Got sick of it.....

Surprised that's registered in them'ere parts. Sounds fun though!
Forum: United States 10-30-2018, 08:58 PM
Replies: 5
Views: 585
Posted By BRADESTAR
Looking at the diagram there. Looks like it goes...

Looking at the diagram there. Looks like it goes to upper intake somewhere.
Forum: United States 10-30-2018, 06:02 PM
Replies: 5
Views: 585
Posted By BRADESTAR
Yep figure 2. After thinking, I'm fairly...

Yep figure 2. After thinking, I'm fairly confident that is the line that goes to FPR on a stock Ti
Forum: United States 10-30-2018, 05:11 AM
Replies: 5
Views: 585
Posted By BRADESTAR
No that's not right. Should be a line on there. ...

No that's not right. Should be a line on there.

I can't think of where that line goes off hand. One of them around there goes back to the fuel filter area. I think onto the FPR. Not sure that it's...
Forum: Suspension 10-22-2018, 11:53 PM
Replies: 19
Views: 2,046
Posted By BRADESTAR
These cars are old and cheap. This forum is the...

These cars are old and cheap. This forum is the best place to look for any information on the Ti! No offense meant Motts, but 8 comments since July '17 ain't exactly stressing the server...

OP,...
Forum: Engine 10-22-2018, 08:50 PM
Replies: 7
Views: 1,386
Posted By BRADESTAR
Any stored codes? I'd start by checking the...

Any stored codes?

I'd start by checking the two ground's. Those can do weird things if they aren't grounded well. One in battery box the other just below it.

Did spark plugs look ok? Are you...
Forum: Engine 10-21-2018, 06:02 AM
Replies: 7
Views: 1,386
Posted By BRADESTAR
This car never ran that you've seen? I'd...

This car never ran that you've seen?

I'd start with the basic stuff. Air , fuel, spark, compression.

Why was someone jumping to starter? When you said "cranking but no spark", was that with the...
Forum: Personal bios and Introductions 10-14-2018, 03:49 AM
Replies: 7
Views: 1,500
Posted By BRADESTAR
Welcome. It wasn't a bad decision. I grew...

Welcome. It wasn't a bad decision.

I grew up in Chicago area. Couldn't stand rusted out cars so moved out West. (not to mention the weather)

Good luck!
Forum: Maintenance 10-14-2018, 03:45 AM
Replies: 1
Views: 717
Posted By BRADESTAR
Fuel pump? Fuel starvation is a bit smoother than...

Fuel pump? Fuel starvation is a bit smoother than electrical loss and should probably stall. "bucking" usually means spark related.

Maybe Coil pack?

...I'd start by checking the grounds. Bad...
Forum: Maintenance 10-14-2018, 03:37 AM
Replies: 3
Views: 839
Posted By BRADESTAR
that's what I'll do. Thanks ZEK. I didn't know if...

that's what I'll do. Thanks ZEK. I didn't know if soap and water would create trouble for the welder.
Forum: Maintenance 10-12-2018, 03:46 AM
Replies: 3
Views: 839
Posted By BRADESTAR
Oil Pan Cleaning

I'm building an M52 for my TI. Dropped the pan in order to get an Achilles baffle welded in. Now I'm wondering how to clean the pan for welding.

I'm guessing brake cleaner is most often used? I...
Forum: Maintenance 10-11-2018, 05:39 AM
Replies: 3
Views: 757
Posted By BRADESTAR
I've always wondered if someone has found a good...

I've always wondered if someone has found a good replacement for that channel liner. Mine is sagging as well.

I assume the answer is to remove it and insulate from the inside. But am all ears if...
Forum: Engine 10-09-2018, 06:26 PM
Replies: 11
Views: 1,134
Posted By BRADESTAR
My experience is that these thermostats get stuck...

My experience is that these thermostats get stuck open. I bought two cars with that going on. I've used the Behr and haven't had any issues.

Possibly you can hack the thermostat part out of the...
Forum: Transmission 10-07-2018, 01:59 AM
Replies: 12
Views: 1,314
Posted By BRADESTAR
Pb blaster over night Torch to heat area ...

Pb blaster over night

Torch to heat area

Impact gun

If that stuff doesn't work, forget about the fluid change. BMW uses "lifetime" oil anyhow..heh.
Showing results 1 to 25 of 451

 
Forum Jump

All times are GMT +1. The time now is 05:32 AM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2019, 318ti.org
[page compression: 71.85 k/80.64 k (10.91%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.