318ti.org forum

Go Back   318ti.org forum > Search Forums
Reload this Page Search Results
Register FAQ Donate Calendar Today's Posts Search

Notices

.
Showing results 1 to 18 of 18
Search took 0.00 seconds. Search: Posts Made By: sleighty
Forum: Maintenance 08-27-2013, 03:47 PM
Replies: 6
Views: 999
Posted By sleighty
Thanks for the advice guys. Is there a way I can...

Thanks for the advice guys. Is there a way I can check if its done any damage?? Nothing is visible and car drives fine.

Does anywhere in the uk sell those pads or will ship to the uk?

Would...
Forum: Maintenance 08-25-2013, 06:16 PM
Replies: 6
Views: 999
Posted By sleighty
Jacking up a crunch noise?

Hi everyone,

I've always been told it wasn't an issue to jack the front of the car up on the rear front LCA bushing that connects to the chassis rail. I wanted to do it today in order to drain the...
Forum: Maintenance 10-17-2012, 07:40 PM
Replies: 3
Views: 2,245
Posted By sleighty
Interesting, i have no overheating issues at all...

Interesting, i have no overheating issues at all and yet it always goes down to the same level which is around quarter full. I fill it and it takes around a week or two to find this level again.
...
Forum: Maintenance 10-13-2012, 02:04 PM
Replies: 3
Views: 2,245
Posted By sleighty
Expansion Tank no cold mark??

Hi Everyone

just a quick one - there isn't a cold mark on my expansion tank. I assume its a pattern one. Can anyone tell me approx how high the coolant level should be or does someone have a pic....
Forum: Engine 09-27-2011, 02:39 PM
Replies: 1
Views: 1,061
Posted By sleighty
Hesitation at low revs and oil use?

Hi everyone.

Had a search round and cant really find a thread with the exact same problem so see what you guys think.

Firstly: the car has developed a low rev hesitation. When the car comes up...
Forum: Knowledge Base 04-07-2010, 06:36 PM
Replies: 31
Views: 61,742
Posted By sleighty
i fixed one of the plastic cooling pipes a few...

i fixed one of the plastic cooling pipes a few months back, refilled and bled the system with no problems i get a nice hot heater when required and the engine sits at the middle of the temp gauge....
Forum: Knowledge Base 04-07-2010, 06:28 PM
Replies: 213
Views: 294,669
Posted By sleighty
hi, ive just fitted a new regulator and sliders...

hi, ive just fitted a new regulator and sliders and i tried the window and the ball popped out of the slider again.

I think the slide guides had been reinstalled on the windows in the wrong place...
Forum: Engine 04-03-2010, 06:07 PM
Replies: 17
Views: 3,155
Posted By sleighty
ive checked the main air hose for cracks however...

ive checked the main air hose for cracks however i didnt look underneath so i will make a point of doing so
Forum: Engine 04-03-2010, 11:04 AM
Replies: 17
Views: 3,155
Posted By sleighty
I have to admit a bad tank of fuel did go through...

I have to admit a bad tank of fuel did go through my mind, with the fuel pump it suprised me how long it took before it sorted itself out. It was restarted etc several times and it took at least...
Forum: Engine 04-02-2010, 10:04 PM
Replies: 17
Views: 3,155
Posted By sleighty
hi, just to give everyone an update, the car had...

hi, just to give everyone an update, the car had a new fuel pump fitted it seems to have sorted the problem. The car ran and stopped after initially fitting the pump but now it runs fine. Bit poor on...
Forum: Engine 03-17-2010, 09:51 PM
Replies: 17
Views: 3,155
Posted By sleighty
the only light i have on is the 'inspection'...

the only light i have on is the 'inspection' light when i start her up thats it.

i guess i have no alternative that to get an expert in a suppose, you dont suppose the fuel lines could be blocked...
Forum: Engine 03-17-2010, 06:12 PM
Replies: 17
Views: 3,155
Posted By sleighty
just tried her again and shes still doing what...

just tried her again and shes still doing what she was before. Rather annoyed as i thought it was sorted. Any more ideas guys? Someone told me camshaft sensor is a possibility?
Forum: Engine 03-17-2010, 04:30 PM
Replies: 17
Views: 3,155
Posted By sleighty
right ok now im really stumped! changed the...

right ok now im really stumped!

changed the fuel filter today, started car up and she was still cutting out etc, tried for a good 10mins and no improvement, tried driving the car (for some reason)...
Forum: Engine 03-17-2010, 03:34 PM
Replies: 17
Views: 3,155
Posted By sleighty
right ive just done the fuel filter, wow thats...

right ive just done the fuel filter, wow thats not the easiest job in the world on these cars

No change, i dont need to purge anything after changing the filter do i?

Anyway the car is still...
Forum: Engine 03-13-2010, 05:23 PM
Replies: 17
Views: 3,155
Posted By sleighty
ive never changed it as ive only had the car 3...

ive never changed it as ive only had the car 3 months, will stick one in tho anyway. Checked the grounds, all look in good condition
Forum: Engine 03-13-2010, 03:12 PM
Replies: 17
Views: 3,155
Posted By sleighty
quick update, car was parked on slope last night...

quick update, car was parked on slope last night with bonnet in highest position. Came to car this morning and she started and idled perfectly, 5 mins went by and no problems. Went for a drive and go...
Forum: Engine 03-13-2010, 02:11 AM
Replies: 17
Views: 3,155
Posted By sleighty
forgot to mention its a 1996 318ti

forgot to mention its a 1996 318ti
Forum: Engine 03-13-2010, 02:04 AM
Replies: 17
Views: 3,155
Posted By sleighty
Help, cut out on idle!!

Hi, ive done a few searches and cant seem to find exactly what im experiencing so here goes.

Id left my car for 3 weeks without use and came to start it today...it fired and then cut out straight...
Showing results 1 to 18 of 18

 
Forum Jump

All times are GMT +1. The time now is 01:18 PM.

Donate - Contact Us - www.318ti.org - Archive - Top

.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 58.80 k/66.69 k (11.83%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.