Forum: Electrical 11-20-2015, 02:10 AM |
Replies: 2 Views: 1,186 Change starter solenoid on car? I'm wondering if anyone has tried changing the solenoid on the starter with the starter in the car. I have an intermittent start problem on my 95 manual trans ti. Occasionally when I turn the... |
Forum: Engine 02-23-2014, 02:22 PM |
Replies: 39 Views: 14,091 |
Forum: Engine 02-23-2014, 02:01 PM |
Replies: 9 Views: 4,737 Mine has the metal oil filter housing. It has... Mine has the metal oil filter housing. It has something like the "bush" thing, but it's integral with the housing and only uses one O-ring. Is yours the plastic filter housing? Maybe it's a late... |
Forum: Engine 02-23-2014, 02:08 AM |
Replies: 39 Views: 14,091 |
Forum: Engine 02-21-2014, 03:55 PM |
Replies: 9 Views: 4,737 |
Forum: Engine 02-14-2014, 09:37 PM |
Replies: 8 Views: 4,108 Thanks for replying, I know this is an old... Thanks for replying, I know this is an old thread. Glad to hear the repair was successful long-term. Any advice for me? Did you use the resistors that come with the BIP373's? I think I'm... |
Forum: Engine 02-14-2014, 08:58 PM |
Replies: 8 Views: 4,108 Thanks, I've been looking into that. It seems... Thanks, I've been looking into that. It seems like some people say if you keep your old chip, mine has a removable chip, that you can use a different DME. If I can fix this one with a $9 transistor... |
Forum: Engine 02-14-2014, 08:14 PM |
Replies: 8 Views: 4,108 Did you put in all four BIP373's? I have the... Did you put in all four BIP373's? I have the same problem; one bad transistor not firing #4 and I'd like to do this to repair the DME rather than buy another and mess around with the EWS. Did you... |
Forum: Engine 02-13-2014, 11:03 PM |
Replies: 3 Views: 1,274 |
Forum: Engine 02-13-2014, 05:44 PM |
Replies: 3 Views: 1,274 |
Forum: Engine 02-13-2014, 02:57 AM |
Replies: 3 Views: 1,763 |
Forum: Engine 02-13-2014, 12:50 AM |
Replies: 3 Views: 1,274 M42 coil fault code, not firing on #2 My '95 Ti started running on three cylinders two days ago. I took out the plugs and they looked OK, but Number 2 looked damp. I took off that plug wire and the engine ran the same, so I assumed it... |
Forum: Suspension 02-22-2013, 06:47 PM |
Replies: 1 Views: 1,202 finally changed struts/shocks at 230k miles I finally got around to doing the front struts and rear shocks on my '95 318ti. I was really surprised at how good the originals were, the car's handling was a little looser, but not too bad. I... |
Forum: Knowledge Base 02-13-2013, 03:06 PM |
Replies: 13 Views: 11,781 Dead link for this DIY The link in this post is no longer active. I'm pretty sure this is the DIY I used when I changed my LCA's and LCAB's a couple of years ago. I was hoping to see it again as I'm doing the same job on... |
Forum: Misc 08-27-2012, 05:11 PM |
Replies: 1 Views: 786 Running rough on re-start My 1995 normally runs great, but if I start it, then shut it off soon afterwards, the next re-start is rough and the CEL comes on until the engine is revved up or run a block or so. Most often... |
Forum: Suspension 06-19-2012, 06:23 PM |
Replies: 3 Views: 1,151 |
Forum: Suspension 06-19-2012, 12:25 PM |
Replies: 3 Views: 1,151 suspension kits from Pelican Parts Wondering if anyone has experience with the stage one suspension kit Pelican Parts sells for the ti. My '95 has the active package, and it still has all the original suspension parts; struts, shocks... |