318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 25 of 33
Search took 0.00 seconds.
Search: Posts Made By: greenie
Forum: Parting out & Parts (US) 08-29-2017, 05:14 PM
Replies: 3
Views: 2,426
Posted By greenie
Sold

Sold
Forum: Parting out & Parts (US) 08-28-2017, 03:46 AM
Replies: 1
Views: 2,085
Posted By greenie
Front brake calipers for solid rotors

I upgraded my front brakes to ventilated rotors so these calipers have been in my garage for several years, always dry with inlets plugged. U clean ;-) I'll throw in the guide pins, and I may have...
Forum: Parting out & Parts (US) 08-27-2017, 10:45 PM
Replies: 3
Views: 2,426
Posted By greenie
Racing Dynamics Sway Bar Set

Front and rear sway bar kit. Racing Dynamics part number 196.81.36.012. Front bar 27mm, rear bar 17mm, each 2 position adjustable. Rear bar never installed, hardware is still in blister pack. ...
Forum: Parting out & Parts (US) 08-27-2017, 10:06 PM
Replies: 0
Views: 1,857
Posted By greenie
318ti Leather Steering Wheel

Steering wheel removed from my E36 318ti, without airbag. Leather has "patina" but is otherwise undamaged. Stitching has worn off on the left and right sides, as seen in the detail photos. Can be...
Forum: Parting out & Parts (US) 08-27-2017, 10:02 PM
Replies: 1
Views: 2,183
Posted By greenie
Panasport Racing 16x7 Competition Wheels

Set of 4 Panasport Racing aluminum wheels 16x7 inches. Offset (ET) is 41mm. Hub-centric, straight and true. Used only for autocross on my E36 318ti. Extra light weight - less than 15 lbs - NOT DOT...
Forum: US and North America 08-27-2017, 09:36 PM
Replies: 5
Views: 2,873
Posted By greenie
I have one that I took out when I installed a...

I have one that I took out when I installed a power antenna in my ti years ago. It has the metal bracket and rubber grommet on it. Looks like they're around $100 new. Make me an offer...
Forum: Exterior 11-10-2016, 07:15 AM
Replies: 0
Views: 1,354
Posted By greenie
Gunk in rear wheel wells

I just did a brake job on my car and noticed quite a lot of gunk/mud buildup in the rear wheel wells near the wheel openings. I cleaned it off with my fingers and a water hose, and I'll check for...
Forum: Interior and ICE 08-02-2012, 03:18 AM
Replies: 210
Views: 170,243
Posted By greenie
I mean reattach the original fabric to the...

I mean reattach the original fabric to the headliner board.
Forum: Interior and ICE 08-02-2012, 01:51 AM
Replies: 210
Views: 170,243
Posted By greenie
My headliner is starting to come loose, but is...

My headliner is starting to come loose, but is otherwise perfect.
Not too bad after 16 years...
Did anyone try to re-glue theirs and succeed?

Milt in Seattle
'96 318ti Sport
no sunroof
Forum: Exterior 02-10-2009, 12:45 AM
Replies: 20
Views: 2,797
Posted By greenie
The 430N set I just took off works OK as long as...

The 430N set I just took off works OK as long as the temps are above freezing.
If you don't have a spoiler they are probably fine.

The 380N set was on my car less than 1 year, before the spoiler...
Forum: Exterior 02-08-2009, 01:26 AM
Replies: 157
Views: 71,720
Posted By greenie
One more thing on the Mr. Lou's / Lift Supports...

One more thing on the Mr. Lou's / Lift Supports Depot struts.
You'll get a better fit if you reuse the spring clips from the stock
BMW struts instead of the ones that come on the new ones.

Milt...
Forum: Exterior 02-07-2009, 11:20 PM
Replies: 20
Views: 2,797
Posted By greenie
Yessir.

Yessir.
Forum: Exterior 02-07-2009, 11:10 PM
Replies: 20
Views: 2,797
Posted By greenie
Kind of eerie that we should both be working on...

Kind of eerie that we should both be working on struts the same day (see post elsewhere). At least my car didn't look like yours afterward ;-)
I use my head (literally) to hold up the hatch when...
Forum: Exterior 02-07-2009, 11:02 PM
Replies: 157
Views: 71,720
Posted By greenie
Re: Another alternative for cheap trunk struts

I just put these on my car today, and they seem to be a good solution. They replaced a set of 430N struts that had been on the car a few years and were starting to have problems in below-freezing...
Forum: Exterior 03-04-2008, 12:41 AM
Replies: 28
Views: 1,808
Posted By greenie
Speaking of Schmiedmann Denmark, there was a...

Speaking of Schmiedmann Denmark, there was a program on the German satellite channel we get (ProSiebenSat1Welt) Sunday evening about 3 guys competing for a mechanic job in Denmark. I was eating...
Forum: Maintenance 02-09-2008, 01:09 AM
Replies: 14
Views: 2,190
Posted By greenie
Castrol Syntec 5W50

Castrol Syntec 5W50
Forum: Lounge 11-08-2007, 07:12 PM
Replies: 354
Views: 167,187
Posted By greenie
My wife calls our ti "greenie" (its Boston...

My wife calls our ti "greenie" (its Boston Green), so I thought I'd use that for my name on this forum, too.
Forum: Maintenance 11-02-2007, 10:57 PM
Replies: 5
Views: 1,446
Posted By greenie
Just had this not too long ago. It was the...

Just had this not too long ago.
It was the driver's side seatbelt latch.
You need to have the dealer or someone with the Peake Research SRS tool read the fault code so you know what to fix.
Forum: Exterior 11-01-2007, 08:53 PM
Replies: 43
Views: 3,885
Posted By greenie
Mallard, Cool website! Who makes the...

Mallard,

Cool website!

Who makes the B36FLLCOM tail lights?
I may want to look for a set when I'm in Germany at the end of the month.
Forum: Transmission 10-31-2007, 07:47 PM
Replies: 6
Views: 1,870
Posted By greenie
When was the last time you changed your...

When was the last time you changed your transmission oil?

My car would sometimes refuse to go into first gear when stopped, but without any grinding. This went away when I switched to Redline MTL.
Forum: Exhausts 10-22-2007, 10:09 PM
Replies: 3
Views: 1,099
Posted By greenie
Try this: ...

Try this:

http://www.318ti.org/forum/showthread.php?t=14657&highlight=mini+cooper&page=2
Forum: Lounge 10-18-2007, 06:39 PM
Replies: 2,264
Views: 744,470
Posted By greenie
Hi, Can you do this one, please? ...

Hi,

Can you do this one, please?

AS97342

Thanks.
Forum: US and North America 10-13-2007, 12:33 AM
Replies: 9
Views: 967
Posted By greenie
Can you post the name of the manufacturer?

Can you post the name of the manufacturer?
Forum: Maintenance 09-14-2007, 09:32 PM
Replies: 12
Views: 4,634
Posted By greenie
Soon after I bought my car (in 1996), I ordered...

Soon after I bought my car (in 1996), I ordered an oil filter wrench through a SnapOn rep. It turned out to be a be a beautifully-made cast alloy tool from Hazet in Germany. Been using it ever...
Forum: Suspension 08-07-2007, 06:04 PM
Replies: 17
Views: 2,440
Posted By greenie
The steel one should be pre-greased as well. You...

The steel one should be pre-greased as well. You probably can't see any grease from the bottom because of the cover over the balls. Can you see any grease from the top?
If there is some grease...
Showing results 1 to 25 of 33

 
Forum Jump

All times are GMT +1. The time now is 08:20 AM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 69.98 k/78.60 k (10.96%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.