318ti.org forum

Go Back   318ti.org forum > Search Forums
Reload this Page Search Results
Register FAQ Donate Calendar Today's Posts Search

Notices

.
Showing results 1 to 6 of 6
Search took 0.00 seconds. Search: Posts Made By: Taymar
Forum: Maintenance 01-30-2011, 06:09 PM
Replies: 6
Views: 4,426
Posted By Taymar
I believe it was £27.75 from GSF car parts in the...

I believe it was £27.75 from GSF car parts in the UK.
Forum: Maintenance 01-23-2011, 11:20 PM
Replies: 6
Views: 4,426
Posted By Taymar
Thanks very much for the reply. The water pump...

Thanks very much for the reply. The water pump wasn't removed. The new thermostat/housing was not a genuine BMW part, it was a Vernet-Calorstat piece P.N 176BM0130 (for M44 engine).

The heater is...
Forum: Maintenance 01-23-2011, 10:06 PM
Replies: 6
Views: 4,426
Posted By Taymar
partial cooling system overhaul, temp issues and lower hose cold

I'm hoping I can get some advice on this for a friend please. The car in question is a 96 318ti, with 67,000 miles.

It was due for a coolant change, and also had signs that coolant had been...
Forum: Engine 10-12-2008, 03:52 PM
Replies: 6
Views: 1,406
Posted By Taymar
Thanks for the info. Where should I be looking...

Thanks for the info. Where should I be looking for the ecu code? is it on a label or on the stock chip itself (assuming it's OBD-I)?

I checked out superchips, theirs has the same gains as the...
Forum: Engine 10-11-2008, 05:37 PM
Replies: 6
Views: 1,406
Posted By Taymar
Info on reputable chips for UK spec cars?

I'm trying to figure out what chips are available for a 1996 uk-spec 318ti (5-speed).

Looking on TMS and Dinan's website, < 1995 US cars (OBD-I?) take a plug-and-play chip which has some nice...
Forum: Exterior 09-20-2008, 12:36 AM
Replies: 6
Views: 2,678
Posted By Taymar
Is rust a concern with drilling holes to install m-tech side sill moldings?

I've found a few DIY guides on installing the m-tech sideskirts onto a 318ti, and I see there's quite a bit of drilling involved.

I'm a bit concerned that these holes would start to rust, even if...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT +1. The time now is 05:40 AM.

Donate - Contact Us - www.318ti.org - Archive - Top

.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 38.40 k/44.53 k (13.77%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.