Forum: Engine 06-28-2013, 09:40 PM |
Replies: 10 Views: 1,554 |
Forum: Engine 06-28-2013, 05:12 AM |
Replies: 10 Views: 1,554 |
Forum: Engine 06-28-2013, 05:00 AM |
Replies: 10 Views: 1,554 |
Forum: Engine 05-13-2013, 06:27 AM |
Replies: 10 Views: 1,554 |
Forum: Engine 05-13-2013, 04:29 AM |
Replies: 10 Views: 1,554 95 runs for a few seconds then dies I'm about at my wits end with this car. I've changed almost everything and no real change. It is hard to start but will start and run for a few seconds then die every time. The dme, fuel pump, cam... |
Forum: Engine 02-04-2013, 12:54 AM |
Replies: 8 Views: 4,082 Good job. I haven't heard to much about people... Good job. I haven't heard to much about people fixing the DME's but you did a good job with yours. As for aligning a new DME, all you have to do take it to the dealer or any other shop that has the... |
Forum: Brakes 02-04-2013, 12:49 AM |
Replies: 7 Views: 5,468 You do want the master cylinder because the... You do want the master cylinder because the travel does increase. Just pay close attention to the master cylinder because there's two main types, one has an M12 line and an M10 and the other has two... |
Forum: Engine Swaps 01-22-2013, 12:43 AM |
Replies: 3 Views: 4,074 I would swap an M50/52 in it with some M3 cams... I would swap an M50/52 in it with some M3 cams and a chip. You can easily make more power than the M54, save a good bit of money, bolt it to your tranny, use any VANOS OBDI harness and throw a chip... |
Forum: Suspension 01-10-2013, 06:31 PM |
Replies: 9 Views: 4,995 |
Forum: Suspension 01-10-2013, 06:28 PM |
Replies: 7 Views: 4,535 I had full urethane bushings in my last E30,... I had full urethane bushings in my last E30, FCABs, and everything in the rear including the diff and it had a bit more vibration but honestly not that bad. It was a DD and was at an HPDE at least... |
Forum: Engine 12-26-2012, 10:09 PM |
Replies: 3 Views: 957 I've used numerous Felpro gasket sets and never... I've used numerous Felpro gasket sets and never had an issue. The MLS gaskets are good for even a good bit of boost so on a stock engine they do great. The head and block do need to be very smooth.... |
Forum: Engine Swaps 12-13-2012, 06:16 AM |
Replies: 3 Views: 1,039 Anything made from 96 on is OBDII, 95 back is... Anything made from 96 on is OBDII, 95 back is OBDI. Its the on board diagnostic system, basically the wiring and computer. Do the swap, get an OBDII computer, have the EWS aligned and it should work... |
Forum: Engine Swaps 12-09-2012, 07:36 PM |
Replies: 5 Views: 1,829 |
Forum: Engine Swaps 12-08-2012, 03:08 AM |
Replies: 3 Views: 1,039 |
Forum: Engine Swaps 12-07-2012, 06:39 AM |
Replies: 1 Views: 1,876 The M42's didn't have a COP either. The E30 M42... The M42's didn't have a COP either. The E30 M42 had individual coils and the E36 has a single multi-coil. If you're wanting the best setup for the COP conversion you want the E30 M42 setup, not the... |
Forum: Exhausts 12-03-2012, 10:17 PM |
Replies: 23 Views: 9,359 |
Forum: US and North America 12-03-2012, 05:50 PM |
Replies: 4 Views: 760 |
Forum: Parting out & Parts (US) 12-03-2012, 05:12 PM |
Replies: 6 Views: 1,966 |
Forum: Parting out & Parts (US) 12-02-2012, 09:49 PM |
Replies: 6 Views: 1,966 |
Forum: Parting out & Parts (US) 12-02-2012, 06:12 PM |
Replies: 6 Views: 1,966 |
Forum: Engine Swaps 12-01-2012, 01:26 AM |
Replies: 17 Views: 3,029 |
Forum: Maintenance 11-30-2012, 05:11 PM |
Replies: 20 Views: 2,531 |
Forum: Exhausts 11-28-2012, 06:35 PM |
Replies: 23 Views: 9,359 |
Forum: Parting out & Parts (US) 11-28-2012, 07:21 AM |
Replies: 6 Views: 1,966 |
Forum: Exhausts 11-28-2012, 07:11 AM |
Replies: 23 Views: 9,359 Ah, so no one has tried it that posted anything... Ah, so no one has tried it that posted anything specific about it? I have no issues ditching the cats in my soon to be S52 swap but I wanted an exhaust that will sound good and give me some power now... |