318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 5 of 5
Search took 0.00 seconds.
Search: Posts Made By: Artin318ti
Forum: Engine 10-08-2017, 03:18 AM
Replies: 11
Views: 6,393
Posted By Artin318ti
If you have another key (second, duplicate,...

If you have another key (second, duplicate, spare, etc.), try them first. It could be that the transponder chip on your key has gone bad, and the ews doesn't send power to the starter and ignition...
Forum: Engine 02-14-2014, 10:30 PM
Replies: 8
Views: 4,081
Posted By Artin318ti
Certainly If you haven't soldered before I...

Certainly

If you haven't soldered before I would suggest getting an old printed circuit board and practicing removal and installation, using cheap radio shack parts. YouTube videos will also...
Forum: Engine 02-14-2014, 09:31 PM
Replies: 8
Views: 4,081
Posted By Artin318ti
mbradican - No. Even though I bought 4...

mbradican -

No. Even though I bought 4 BIP373's I only replaced the damaged one, and it worked. It's been more than 9,000 miles since the repair and it's still holding.

As far as I remember...
Forum: Engine 02-05-2013, 12:12 PM
Replies: 8
Views: 4,081
Posted By Artin318ti
After being stranded for more than a week at...

After being stranded for more than a week at northeast winter conditions - no fun by any standard - I'm planning on getting a spare DME. I will follow up on your lead and have it recoded for my car....
Forum: Engine 02-03-2013, 11:18 PM
Replies: 8
Views: 4,081
Posted By Artin318ti
DME M42 Repair:

Sorry for the long-winded post, but I'm hoping to be thorough.

It started on a very cold morning [0-F]. I still don't know if that was a factor...

So, after the car warmed up normally I...
Showing results 1 to 5 of 5

 
Forum Jump

All times are GMT +1. The time now is 05:11 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 36.37 k/42.04 k (13.47%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.