Forum: Transmission 10-08-2018, 12:55 PM |
Replies: 12 Views: 7,172 For BMW Automatic Transmission. After you drain... For BMW Automatic Transmission. After you drain & snug tite the bolt, remove the fill bolt and fill til it drips, then replace bolt. THEN start the car and get her to full temperature. the fluid is... |
Forum: Transmission 10-06-2018, 02:09 PM |
Replies: 12 Views: 7,172 rounding my bolt I suggest you buy an LW10 vise grip (locking wrench) and add it to your tool arsenal. Try ebay. yes - counter clockwise, Lefty Loosey. |
Forum: Maintenance 07-05-2018, 03:41 PM |
Replies: 1 Views: 1,402 |
Forum: Maintenance 07-05-2018, 03:36 PM |
Replies: 1 Views: 768 How much ATF I'm replaceing the shift solenoids in my A4S 270R '96 318ti. How much full synthetic Redline Dextron III ATF fluid should I buy? |
Forum: Transmission 06-28-2018, 04:06 PM |
Replies: 0 Views: 711 318ti automatic shifting harsh She "clunk shifts" 1st to 2nd reguardless of accelleration. It did this before I replaced the drive shaft. Any help?:confused: |
Forum: Maintenance 10-24-2017, 11:03 AM |
Replies: 3 Views: 2,276 start removing at air box, remove/inspect and... start removing at air box, remove/inspect and clean, thru throttle body, then remove plenum and change out the pcv-ccv. use new gasket and vacuumn hoses. only use mass air flow cleaner when you do... |
Forum: Parting out & Parts (US) 10-24-2017, 10:41 AM |
Replies: 19 Views: 12,425 |
Forum: Engine 06-03-2014, 01:03 AM |
Replies: 10 Views: 6,271 |
Forum: Engine 02-27-2014, 05:07 PM |
Replies: 9 Views: 5,058 |
Forum: Engine Swaps 01-05-2014, 03:23 PM |
Replies: 3 Views: 858 |
Forum: Engine 01-05-2014, 03:11 PM |
Replies: 3 Views: 1,564 |
Forum: Engine 10-26-2012, 06:51 PM |
Replies: 76 Views: 27,339 |
Forum: Engine 09-20-2012, 01:24 AM |
Replies: 76 Views: 27,339 Burping an M44 '96 318ti THIS works EVERY TIME. Pour 50/50 into motor hose, you can blow pressure to speed things up til coolant comes up the one foot long extra hose you put on radiator top nipple. Elevation of these... |
Forum: Electrical 07-03-2012, 10:46 PM |
Replies: 25 Views: 5,426 sensor its on passenger side of radiator. It won't work if air is in there. I had to incline the front of the car up (2' high) take radiator hose off dr side hold up high. Then I took another hose, attached... |
Forum: Engine 05-24-2011, 12:51 AM |
Replies: 76 Views: 27,339 I had a hard time with mine. I used my old top... I had a hard time with mine. I used my old top water hose. I removed the top new radiator hose end and put the old one on and filled both and held both hoses high as possible while filling with... |
Forum: Engine 02-18-2011, 10:02 PM |
Replies: 0 Views: 1,639 Bleeding an Overheater (Tip) Getting the air out of a TI was frusterating, as it continued to overheat after following all the technics of loosening the bleeder after cold and the nose of vehicle Highly elevated. I removed... |
Forum: General Chit Chat 02-13-2011, 11:22 PM |
Replies: 5 Views: 1,304 |
Forum: Engine 03-12-2010, 03:50 PM |
Replies: 13 Views: 12,145 |
Forum: Engine Swaps 02-25-2010, 09:15 PM |
Replies: 7 Views: 4,907 Fan I have m44 electric fan (item 4) I will trade for m44 mechanical fan. Bills86e@aol.com |
Forum: Electrical 02-25-2010, 08:58 PM |
Replies: 4 Views: 1,955 |
Forum: Engine 01-07-2010, 07:37 PM |
Replies: 13 Views: 12,145 |
Forum: Electrical 11-05-2009, 03:57 AM |
Replies: 17 Views: 3,575 |
Forum: Engine 10-23-2009, 04:42 PM |
Replies: 25 Views: 25,867 |
Forum: Engine 10-20-2009, 12:54 PM |
Replies: 13 Views: 2,391 |
Forum: Engine 10-20-2009, 12:49 PM |
Replies: 25 Views: 25,867 |