318ti.org forum

Go Back   318ti.org forum > Search Forums
Reload this Page Search Results
Register FAQ Donate Calendar Today's Posts Search

Notices

.
Showing results 1 to 8 of 8
Search took 0.00 seconds. Search: Posts Made By: fmorelli
Forum: Engine 05-09-2018, 02:18 AM
Replies: 13
Views: 9,530
Posted By fmorelli
So we went ahead and fixed the clasp. Still...

So we went ahead and fixed the clasp. Still getting P0420. We put new Bosch upstream and downstream oxygen sensors in the car in the last 30k miles. Replaced the MAF as well. Continues to throw...
Forum: Engine 05-04-2018, 02:27 PM
Replies: 13
Views: 9,530
Posted By fmorelli
Sorry to resurrect this old thread. But we have...

Sorry to resurrect this old thread. But we have literally the same problem ... P0420, and the rear clasp on the side of the airbox was bent and not locking. I cannot believe this fixes a P0420....
Forum: Engine 03-30-2018, 05:06 PM
Replies: 4
Views: 1,480
Posted By fmorelli
Thanks ... took a while of searching but figured...

Thanks ... took a while of searching but figured it out. For some reason my son had removed it when we were doing the timing covers. For anyone else wondering, this video, at this time, shows it:...
Forum: Engine 03-30-2018, 01:30 PM
Replies: 4
Views: 1,480
Posted By fmorelli
Thanks! Strange, we can't seem to sort this out....

Thanks! Strange, we can't seem to sort this out. Can you tell us which part it is in the diagram?

http://www.realoem.com/bmw/enUS/showparts?id=CG73-USA-11-1997-E36-BMW-318ti&diagId=11_6106
...
Forum: Engine 03-29-2018, 06:58 PM
Replies: 4
Views: 1,480
Posted By fmorelli
Mystery part! ID that part.

Ok ... we pulled the head off an M44 in our 1998 318ti, but for the life of us can't find the following parts in realoem. We think the bolt actually goes inside the threaded sleeve. Ideas?

Filippo
Forum: Engine 11-01-2017, 07:27 PM
Replies: 1
Views: 872
Posted By fmorelli
M44 head - rebuild/used/reman advice

Hi all, I have a 250 casting M44 head from my son's 1998 318ti. The car overheated several times. I am considering my options and looking for advice:

Rebuild - I'm in the Washington DC area. Any...
Forum: Parting out & Parts (US) 06-25-2016, 07:49 AM
Replies: 0
Views: 1,347
Posted By fmorelli
Looking for hellrot 318ti parts

Looking for a driver fender, driver door, driver mirror in Hellrot.

Thanks,

Filippo
Forum: Lounge 01-25-2015, 03:56 AM
Replies: 0
Views: 1,160
Posted By fmorelli
Idle Control Valve connector issue

Hi all,
We got my son a 98ti in the Fall. Over the winter here, we've basically pulled it all apart for an overhaul (minus engine internals which were not touched, most everything is new). The...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT +1. The time now is 10:51 PM.

Donate - Contact Us - www.318ti.org - Archive - Top

.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 42.56 k/49.11 k (13.33%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.