318ti.org forum

Go Back   318ti.org forum > Search Forums
Reload this Page Search Results
Register FAQ Donate Calendar Today's Posts Search

Notices

.
Showing results 1 to 16 of 16
Search took 0.00 seconds. Search: Posts Made By: PlusOne
Forum: Exhausts 04-12-2016, 04:08 AM
Replies: 6
Views: 4,794
Posted By PlusOne
bmw 2.8L swap, muffler drone elimination set up

Here is my solution. A stainless 2-1/2" Dual Pipe magnaflow. It flows free and is nice and throaty but not to loud. The side chambers are helmholtz resonator chambers i developed and had made custom...
Forum: Engine Swaps 04-12-2016, 03:20 AM
Replies: 44
Views: 65,327
Posted By PlusOne
Check out this link ...

Check out this link
http://www.r3vlimited.com/board/showthread.php?t=154876
Forum: Engine Swaps 04-12-2016, 03:15 AM
Replies: 44
Views: 65,327
Posted By PlusOne
I removed the pin and transferred it to the other...

I removed the pin and transferred it to the other connector. If i recall it was fairly easy. There is a plastic retaining/locking ring on the face of the connector. You twist this slightly ccw to...
Forum: Engine Swaps 04-11-2016, 01:54 AM
Replies: 44
Views: 65,327
Posted By PlusOne
Trusted1 i think your answer is in post 5 by...

Trusted1 i think your answer is in post 5 by Samdemage It may be you need to move pin 9 from connector x6031 to pin 8 of connector x20 ( you will also find that you are getting a muffler flap...
Forum: Engine Swaps 04-07-2016, 12:21 PM
Replies: 44
Views: 65,327
Posted By PlusOne
318ti to 328 swap EVAP CEL ISSUE

hey Trusted one

I had the same EVAP CEL with my 98 OBD2 to OBD2 swap. It turns out it was a pin out wiring problem to the ECM. I wish I could remember exactly what wires I added or changed but...
Forum: Engine Swaps 02-29-2016, 01:37 PM
Replies: 3
Views: 3,249
Posted By PlusOne
For the most part you can mix and match the front...

For the most part you can mix and match the front and rear sections of drive shafts out of the auto and manual to come up with the right length and driveshaft holes pattern. The rear sections should...
Forum: Engine Swaps 02-08-2016, 04:46 AM
Replies: 2
Views: 3,308
Posted By PlusOne
Neutral safety switch vs brake switch, cruise control

Ok I think i answered my own question. According to the 328i wiring diagram (see attached) and although the part numbers per Real OEM are different both the brake switch and the clutch switch are...
Forum: Misc 02-03-2016, 01:31 PM
Replies: 4
Views: 1,401
Posted By PlusOne
Can you here the fuel pump run when you put the...

Can you here the fuel pump run when you put the ignition in the run position? If not check your fuel pump fuse. If it runs, I'd look at the fuel filter it may be clogged
Forum: Engine Swaps 02-03-2016, 01:26 PM
Replies: 3
Views: 2,251
Posted By PlusOne
fyi - no need to swap the antenna ring. In...

fyi - no need to swap the antenna ring. In principle the DME & EWS & key chip must match. The antenna ring just sends a signal any working ring will do.
Forum: Engine Swaps 02-03-2016, 01:19 PM
Replies: 3
Views: 2,251
Posted By PlusOne
Maybe a dumb question but did you swap the chip...

Maybe a dumb question but did you swap the chip in your key with the donor key chip? The ews from the donor is looking for donor key chip. Some people tywrap the donor key in the antenna ring and...
Forum: Engine Swaps 01-21-2016, 04:09 AM
Replies: 2
Views: 3,308
Posted By PlusOne
Smile Neutral Safety Switch, obd2 328i engine and manual trany swap

Hello all
I've been lurking for awhile and found this site very helpful with my conversion. I could use some enlightenment on the neutral safety switch with my swap. Here is the specifics

98...
Forum: Engine Swaps 01-18-2016, 01:19 PM
Replies: 6
Views: 1,646
Posted By PlusOne
Bazuka Joe Care to share what you figured out?...

Bazuka Joe
Care to share what you figured out? Ill be doing this soon. I've been prepping a 5 sp manual and rear LSD differential and e30 axles to swap into my 98 ti. I've already done the motor...
Forum: Engine Swaps 05-28-2015, 04:41 AM
Replies: 11
Views: 12,398
Posted By PlusOne
I think I got this right, the 328 at the firewall...

I think I got this right, the 328 at the firewall has two hoses leading into the interior heater cores with a single return hose for a total of three at the firewall. The ti has one hose in and one...
Forum: Engine Swaps 05-19-2015, 03:17 AM
Replies: 11
Views: 12,398
Posted By PlusOne
I used the 318ti heater valve, like the one you...

I used the 318ti heater valve, like the one you have shown. Looks like you have it figured out. I don't think I'd run it straight through without a valve. It's going to get hot inside without it...
Forum: Engine Swaps 04-26-2015, 12:07 PM
Replies: 20
Views: 43,451
Posted By PlusOne
I had to run the wire up from engine bay plug...

I had to run the wire up from engine bay plug through the fuse box and fire wall to my cluster as per the OP. I did not have the enhanced OBC display that I could tap into. My MPG works great now. ...
Forum: Personal bios and Introductions 01-20-2015, 05:05 AM
Replies: 331
Sticky: Poll: Age Demographics
Views: 161,762
Posted By PlusOne
56, Building a new toy, almost done

98 318ti with 98 m52b28 swap and hd bilsteins
Showing results 1 to 16 of 16

 
Forum Jump

All times are GMT +1. The time now is 03:35 PM.

Donate - Contact Us - www.318ti.org - Archive - Top

.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 56.39 k/63.86 k (11.69%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.