318ti.org forum

Go Back   318ti.org forum > Search Forums

Notices

.
Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: robcarync
Forum: Suspension 01-07-2013, 03:06 AM
Replies: 4
Views: 2,205
Posted By robcarync
Dealers will always rip you off...dealer = last...

Dealers will always rip you off...dealer = last resort. Mega expensive!

First, when you say your wheel shakes, do you mean steering wheel or tire/rim vibration?

1) I would investigate the...
Forum: Suspension 01-06-2013, 11:49 PM
Replies: 4
Views: 2,205
Posted By robcarync
as a general rule of thumb...don't ever go to a...

as a general rule of thumb...don't ever go to a dealer :P

Not sure if the wheel shaking is because of a power steering fluid leak though. Mine was leaking power steering fluid, and you knew it...
Forum: Suspension 01-06-2013, 01:21 AM
Replies: 6
Views: 2,158
Posted By robcarync
Did the bushings keep rotating out of alignment? ...

Did the bushings keep rotating out of alignment? The car for right now drives better than it ever has...but like I said...time will tell on the eccentric bushings if they will hold the alignment.
...
Forum: Suspension 01-04-2013, 09:00 PM
Replies: 6
Views: 2,158
Posted By robcarync
Talking 95 318ti camber kits after lowering

Hey guys, no real question here, just more of an FYI/story

Several years ago (probably 7 years now) I scored some HR Race springs and Tokico Illumina shocks for a killer deal on here and lowered...
Forum: US and North America 01-04-2013, 08:31 PM
Replies: 4
Views: 4,460
Posted By robcarync
WTB GOOD Dove Grey Door Panels

I have a 95 TI in desperate need of a dove grey door panel.

Mainly, the drivers door panel has a cracked upper handle mount, so every time you pull on the door handle to shut it, the panel and...
Forum: Exterior 04-16-2012, 11:27 PM
Replies: 0
Views: 2,944
Posted By robcarync
Getting Rid of Grey Trim...Painting is Really Easy

Haven't posted in 2 years...but I am back to share something cool! My 318ti is still going with 175k on it...

Want to get rid of grey trim? It isn't hard to paint it. The difficult part would...
Forum: Engine 04-25-2010, 07:06 PM
Replies: 15
Views: 9,197
Posted By robcarync
lol ^^^ So while attempting to replace a...

lol ^^^

So while attempting to replace a number of parts (thermostat, water pump, plastic coolant lines that broke) my water pump is giving me a lot of trouble.

Bentley says to thread two 6mm...
Forum: HVAC 04-24-2010, 03:19 AM
Replies: 21
Views: 4,940
Posted By robcarync
scratch that...not the same piece...my plastic...

scratch that...not the same piece...my plastic piece that broke is under the fuel rail pretty much...and now im stuck....forum search....here I come!
Forum: HVAC 04-24-2010, 03:08 AM
Replies: 21
Views: 4,940
Posted By robcarync
mine broke and left my coolant-less...and i went...

mine broke and left my coolant-less...and i went ahead on my own removing the intake manifold and all the goodies....yay for not reading the forum first!

DOH!@@@@

Oh well...it was fun!!!!
Forum: Air Filters/Intakes 04-19-2010, 04:19 AM
Replies: 11
Views: 8,722
Posted By robcarync
Interesting because in the autospeed article they...

Interesting because in the autospeed article they found a negative pressure differential in that KN location....right below the bumper meaning air would be pushing in the wrong direction...

of...
Forum: Air Filters/Intakes 04-18-2010, 07:27 AM
Replies: 11
Views: 8,722
Posted By robcarync
well considering my previous intake was a cone...

well considering my previous intake was a cone filter without the "airbox heat shield" that was dirty and falling apart I would say I did not lose anything from this compared to my previous set up....
Forum: Engine 04-17-2010, 04:54 AM
Replies: 3
Views: 1,389
Posted By robcarync
have you noticed any other things such as a...

have you noticed any other things such as a decrease in gas milegage? I am convinced my thermostat is stuck open because it takes a long time to heat up to 12 oclock, the heating in the cabin is...
Forum: Air Filters/Intakes 04-17-2010, 04:17 AM
Replies: 11
Views: 8,722
Posted By robcarync
I think it will be easiest to take the stock top...

I think it will be easiest to take the stock top of the airbox...cut a hole in the top for the pipe to go through...and use the stock clips to clip the top on to protect from heat coming over the...
Forum: General Chit Chat 04-16-2010, 07:40 PM
Replies: 10
Views: 5,061
Posted By robcarync
I'm digging the flag...I almost need to get one...

I'm digging the flag...I almost need to get one now!
Forum: Air Filters/Intakes 04-16-2010, 07:08 AM
Replies: 11
Views: 8,722
Posted By robcarync
Ahh good call...didn't think about the height. I...

Ahh good call...didn't think about the height. I will have to work on that...shouldn't be too hard.
Forum: Engine 04-16-2010, 07:04 AM
Replies: 13
Views: 3,582
Posted By robcarync
intake, chip, cat back is about all you can do. ...

intake, chip, cat back is about all you can do.

headers won't give you any help.

you can do short shifters if you want...doesn't make the engine faster of course but it doesn't hurt overall...
Forum: Engine 04-16-2010, 06:59 AM
Replies: 7
Views: 2,218
Posted By robcarync
Problem solved: upon further research, a bad...

Problem solved: upon further research, a bad crankcase ventilation valve can cause: rough idle, intermittent check engine lights, and high pitched screeching sounds...all which I had.

$70 part,...
Forum: Air Filters/Intakes 04-16-2010, 06:51 AM
Replies: 11
Views: 8,722
Posted By robcarync
My Super Cool Intake I Made

My middle lower grill on my front bumper (not kidneys, the one between the fog lights) has been popping out and clips were coming lose and it was looking ghetto. Thus, I decided to do a bumper...
Forum: Knowledge Base 04-14-2010, 11:05 PM
Replies: 12
Views: 29,565
Posted By robcarync
Just replaced my PCV valve and hose...what a pain...

Just replaced my PCV valve and hose...what a pain for only 2 bolts!
Forum: Engine 04-13-2010, 10:26 PM
Replies: 13
Views: 1,928
Posted By robcarync
You can always give it a try....especially for a...

You can always give it a try....especially for a low price. Dinan is conservative...as been mentioned before a lot of their stuff is dicontinued for the 318ti so it may not be a bad idea to give...
Forum: Engine 04-13-2010, 07:14 PM
Replies: 13
Views: 1,928
Posted By robcarync
Dinan is tested and trusted...it gives gains and...

Dinan is tested and trusted...it gives gains and also works well with other bolt ons like exhaust and Intakes. I liked my chip and I noticed a difference even with my automatic transmission. I have...
Forum: US and North America 04-08-2010, 06:58 PM
Replies: 14
Views: 2,361
Posted By robcarync
How much would you want for the lower portion of...

How much would you want for the lower portion of the airbox? I only need the bottom half. Shipping to 27513 (NC)
Forum: US and North America 04-06-2010, 04:38 PM
Replies: 15
Views: 3,456
Posted By robcarync
damn i knew i should check back here more...

damn i knew i should check back here more often....could have used this one!
Forum: Engine 04-06-2010, 04:34 PM
Replies: 7
Views: 2,218
Posted By robcarync
Bump...any info?

Bump...any info?
Forum: Engine 04-06-2010, 04:33 PM
Replies: 16
Views: 7,974
Posted By robcarync
Good to hear...I have a 95 auto 318ti and have...

Good to hear...I have a 95 auto 318ti and have had the same codes before...

Knock sensor 3/4 with a slightly rough idle...I couldnt find any information so I ended up just taking it to the local...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT +1. The time now is 05:54 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
[page compression: 71.97 k/80.75 k (10.87%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.