How to:=- Fit a 1 series badge to a E36
I did this mod about a month plus back and people been asking how I did it, so I'm doing this little write up.
this mod will only work if you have a boot popper wired up and working. It will not work if you don't have one.
parts:=-
you need 1,2,3,4,5 and 10 
tools:=-
Some thing to cut the boot away. I used a dermal multi tool
T20 torx for the new badge
The E36 badge is 89mm in diameter, which is the same diameter of the hole that is needed for the badge.
The boot is twin skinned; you need to cut away the outer skin. Make sure it is round and 89mm. do not make it bigger or egg shaped as it will fcuk it all up really.
Once you cut a way the outer skin to make the hole you should be left with this.
