Here is a small update, I worked on the Throttle body plate adapter this morning, its almost ready for welding. Ill probably have it done tomorrow morning (i usually work on the car in the early morning before i head to the gym.)
This is the Plate after initial drilling
Here it is with the final shape cut into it and deburred/round the edge.
Then i rummaged around the garage and found some left over 2.5" crush bent exhaust pipe that i cut at a drastic angle to reach the pipe going to the supercharger inlet.
The plate looks really long, but i plan on bending part of the bottom to connect with the airbox anchor tabs that are in the engine bay to assist in holding the throttle in place. Ill add another picture tomorrow to show how its all connected.