Have both problems on my m50 swapped obd1 1995 ti. speed sensors get dirty and the sensor is cheap enough but taking it out is ..... difficult. where is the charcoal canister located - I read that it should be behind driver left panel - opened that up and there is nothing there ...... wtf, but on pass side, the expansion tank (with blue hose attached) is there so it must have either been relocated to the front or was never in that location in 95's .... will go down and check more thoroughly because that would be where the purge valve is attached to....this is bumfluffery i say programming it out seems like a good idea though .... this it does not affect performance..... __________________ minimum weight maximum stomp Last edited by e30sequel; 12-03-2012 at 05:05 AM. |