Okay after digging around i found this for my model
Quote:
1) Prise out the rubber bung from the remote receiver.
2) Insert a thin screwdriver into the hole and flick the coding switch to the right to set the remote receiver into “program” mode.
3) Press the red button once on each remote (max 4 remotes).
4) Flick the coding switch back to the left and replace the rubber bung.Your fobs should now work. |
Heres what mine looks like:
I found the little switch and followed the steps (with it plugged in unlike in pic lol) but still no joy
Naff receiver? it looks like its been opened up before and played about with
Quote:
| If there still seems to be a problem prise the remote receiver off the control unit to reset it. When you replace it (be careful you don’t bend the pins) the central locking should close & open. Re-code your fob as in steps 1 to 4. |
it also did this exactly as it should be wont program to the fob for some reason