Quote:
Originally Posted by Rellik29  Would this be the best process to 'burp' my car?
1. Wait till the car is 100% cooled off.
2. Top off the coolant with the cap and bleeder off (the bleeder next to the radiator cap).
3. Wait till the coolant/water comes out of the bleeder w/o any bubbles.
4. Screw back on the bleeder.
5. Run the car with full blast heat till it gets to the mid-mark for a while.
6. Turn it off, let it cool off and check the water level.
Now, should I fill the tank again, take off the bleeder to make sure there are no more bubbles, top it off and repeat? |
Um... at some point before Step 3, you're going to need to start the car.
I know... I know... I'm being pedantic and pointing out the obvious... but I couldn't resist.
JMJ