View Single Post
Old 07-03-2019, 05:13 PM   #9
BigDaddyDaveH
Junior Member
 
Join Date: Jun 2019
Location: South Bend, IN USA
Posts: 7
iTrader: (0)
Default

As stated earlier, the grommet is just a rubber sleeve and mine popped right out with a bit of urging with a pick between the grommet and the head. The check valve pulled right out with a pair of needle nose pliers and the new one dropped right in place after I cleaned out the oil feed chanel and the little machined step the valve sits on. Pushed the grommet back in easy as pie. The grommet sits just proud of the head surface and seals between the valve and the gasket.
BigDaddyDaveH is offline   Reply With Quote