View Single Post
Old 07-02-2016, 04:55 AM   #14
e30topdown
ti Daily
 
e30topdown's Avatar
 
Join Date: May 2015
Location: Austin, TX
Posts: 43
iTrader: (0)
Default

Pulled the instrument cluster to replace the CEL bulb that I hadn't noticed had burned out (because the PO let it stay lit for almost five years)...it failed inspection because of it. I then had to do a drive cycle to make all the OBD2 emission sensors ready, because I disconnected the battery to pull the cluster. But after the drive cycle, all but one was ready and on the way back to the inspection station, that one reset. So it passed just fine.
Oh, and I adjusted the driver's door window regulator and front window guide so the clip would hold the arm permanently! Thanks, CoolJess!
__________________

1992 325iC M Technic appearance Diamantschwarz 5 spd. heated seats
1993 325iC Schwarz II 5 spd. SOLD
1997 318ti Active Boston Gruen, Sandgrau w/M Technic interior swap Millpoint Gray
1999 M Roadster Dakar Yellow II, Dinan Stage 3 software, high flow throttle body, and CAI
2001 Z3 3.0i Coupe Black Sapphire Metallic
BMW CCA 369408
e30topdown is offline   Reply With Quote