View Single Post
Old 12-13-2013, 12:37 AM   #5
projekt EPiK
Senior Member
 
Join Date: Nov 2009
Location: mbsc
Posts: 570
iTrader: (4)
Default

Im actually starting to think that may be it. There is a magnaflow on it so the PO replaced it before obviously. Guess ill pull it off tomorrow and check it out.

I did a compression test earlier to rule out anything there..not bad at 175-185 on a barely warm engine.
The plugs looked a little lean so I pulled the iridium plugs and put in a new set of normal plugs.
Swapped the fuel pressure regulator out after pulling vacuum line and smelling fuel in it.

Went for a drive and while it did idle a little smoother the was no change in rpm/power.

I just put a can of seafoam in the tank tonight so it can cleans things up there too.
projekt EPiK is offline   Reply With Quote