Quote:
Originally Posted by jeff318 you guna need a driveshaft off a manual ti. and a diff off one too. unless you want a lsd one you could find that on bimmerforums.com its not that bad to do. youll need trans, clutch kit, flywheel, all shifter things, rear main seal, new trans cross member off a manual. it will fit right in no problem, i didnt even swap the center cnsole out it just kinda fit nicely. you need to hot wire the neutral saftey switch to get it to turn on, but its not bad. get the bentley book and your good |
Not worried about the drive shaft, i can get it cut, welded and rebalanced. just wanted to know if the parts were compatible before I purchase the 92 318i sedan for parts.
I will change every possible component on the exterior of the gearbox including shift linkage, seals etc. I have an e36 bentley cant remember if it covers the ti.
I will install an e30 373 LSD into the ti.
What did you get your parts from?
I will take pics and document the whole progress for other members here.
Thanks for all the help guys.