Quote:
Originally Posted by BMW318isZ3 Engine is out and new one is in. I ran into a little trouble with some parts from the 318ti which did not match the z3 but nothing a little swapping around could not fix. Different header, intake manifold air intake and wiring harness. The problem I have now is that the transmission and the engine are sitting about an 3/4 of an inch apart. I can get a bolt started at the bottom but not at the top. I don't want to bend the input shaft of the transmission. Any advice to get them closer. Should I take off the transmission and try and slide it forward? The engine is bolted in place and all connected including, fuel lines, radiator, intake wiring harness all except starter motor. Thanks, M |
Is this a manual tranny car?