View Single Post
Old 10-26-2011, 02:30 PM   #7
Crashaddict
Senior Member
 
Crashaddict's Avatar
 
Join Date: Jul 2011
Location: SoFla
Posts: 482
Vehicles
iTrader: (0)
Default

Quote:
Originally Posted by urbanmisfit View Post
I use a template tool and make the floor in 2 pieces (lengthwise). Once you get a good fit you can push each piece tight against the side and then mark them for the center cut.
On the last one I did I used split black hose to trim the edges where the floor meets the side panels.
Best would be if you can figure out a ledger for the floor to rest on and be screwed to but that may be difficult because of the soft panels...
thats one of the issues im trying to work out. i figure if i make it one solid piece, the wheel wells will hold it in place. ill be removing that fat sensor from the seatpan, and am considering using the screws from that to make it sit flush against the pan. for the sides im considering just making a solid skirt covered in carpet, that i can secure in place of the bolsters, ind like to use foam, but foam+glue does not exactly work too well
Crashaddict is offline   Reply With Quote