Re: Suspension Specs Dusten: The Before numbers are irrelevant, as you know. The After numbers are interesting. I will only comment on the front (I don’t have much experience with rear alignment yet.) I normally run the same camber on the left and right sides. Wont more negative camber left than right cause a little ‘pulling’ to the right? Maybe that’s what you want. Your caster looks fine. I do my own alignments and I have never measured mine. I wouldn’t think that the slight variation in caster left to right is a problem. ‘Specified’ toe is toe-in. So you have 0.29” toe-in. That’s a lot of toe in. Too much, I think. I would normally run Zero toe, but I have more negative camber (I have about -2.5° each side.) I would think that you would want 0.125 total toe in at the most. 0.06 or so would be my preference for your set-up. Otherwise, expect premature front tire wear. These are my thoughts, for what they’re worth. Steven Park Burlington Ontario CANADA |