Quote:
Originally Posted by wolferj It was basically the same process as the seats. 1. Serious cleaning / de-greasing. 2. Prep. Light sanding with coarser paper, then finer grit, and finish with very fine grit. Clean all areas well, leaving no fuzz or dust. 3. Filled the pitted areas with the filler product, then a top coat of the filler for an even surface. 4. Very light sanding of the filler product after it cured for a smooth finish. I used a scouring pad for all my final finish sanding. 5. Brush on the dye in several light coats. Good luck! |
Awesome.
Thanks for the feedback.
Just another question about it.
Did you sand back the whole wheel to give it an even finish or just the affected area?