Been a while since I updated.
So the suspension and brake upgrades went pretty smoothly until I got a little careless with the dremel when trimming the rear brake backing plates. I ended up nicking the passenger brake hard line and while it didn't cause a leak it certainly introduced a spot of weakness. The last thing I wanted was to be on track and lose brake pressure due to a rupture at that location.
Luckily, NAPA sells lengths of european brake line that work and are coated like the OE lines. I did also order a couple of OE lines because the length of those was slightly different than the NAPA line.
Since this was my first time bending brake lines I used the NAPA stuff to practice and make sure I didn't screw up with the OE stuff. One thing to make sure of if you do this yourself is to get a good pair of brake line pliers. I looked through all the pairs available at the local stores and only one had jaws that lined up correctly. Even then, I ran a file through the jaws to clean up some small burrs before I used them on the lines.
Pics below, used the old line as a guide and kept holding it up to the trailing arm to make sure it would route through the clips. When working with the pre-flared lines it's critical to keep the bends correct because there is not much slack left by the time to get from one end to the other.