View Single Post
Old 03-10-2016, 01:43 AM   #2
xxxJohnBoyxxx
Senior Member
 
Join Date: Dec 2007
Location: Gulfport, Florida
Posts: 3,208
iTrader: (1)
Default

Ok if the car push starts DME and EWS are aligned. I can thin of two things that you might need check.

1. Are you 100% sure you put the correct wires to their small pole on the starter?

2. Are you sure the key you purchased is aligned with the EWS and in the key roll? If not you can connect the two thick wires on the EWS to bypass starter kill function.

If you connect those two thick wires on the EWS and it doesn't crank then you have a break in the starter engage wire from EWS unit to starter.

Hope this helps, John S
xxxJohnBoyxxx is offline   Reply With Quote