small updates today, I fixed the battery hold down, couldn't get the broken bolt out so I just drilled a new hole, drilled holes in the bottoms of my taillights, water kept getting in and drilling holes was cheaper and easier than replacing the gaskets, and I put my Sparco harness in on the drivers side. I'm not sure if I'll keep the harness in or not, the rear seat belt bolt that I attached it to is way off center compared to the seat. and yes, I know that that's an unsafe way to install a harness, if I was risking hitting anything other than cones I wouldn't have done it.
I've also noticed that the car feels a little bit sluggish when I start accelerating, the PO replaced the cam position sensor with an aftermarket one that keeps setting off the CEL. anyone know if a bad cam sensor can cause poor low end power? |